Filter Results By:

Products

Applications

Manufacturers

Showing results: 2491 - 2505 of 3199 items found.

  • 14-slot ATX-supported PICMG 1.3 Bus Passive Backplane

    FAB118 - Axiomtek Co., Ltd.

    The FAB118 offers one PCIe x16 slot, five PCIe x4 slots and six 32bit/33MHz PCI slots as well as the PICMG 1.3 slot for the SHB (system host board). The onboard 24-pin ATX power connector and 8-pin connector for thermal detected board are featured. Furthermore, the backplane supports two high speed USB 2.0 ports. The FAB118 is designed for the 14-slot industrial chassis, such as Axiomtek's AX61460, AX6145, AX61400, AX6156E/LE/LLE, and AX61491.

  • RF Components

    Copper Mountain Technologies

    Using a Vector Network Analyzer (VNA) for RF component testing for design and manufacturing is based on how the component performs. The analyzer is used in multiple ways from design to manufacturing to tuning, field monitoring and maintenance of antennas, filters, mixers, amplifiers, circulators, isolators, and other RF components. Key considerations component designers should pay attention to when finding an analyzer that fits their needs is a great dynamic range, low trace noise, and fast measurement speed.

  • Turbine Control Solutions

    NRG Systems, Inc.

    NRG’s turbine control sensors are engineered exclusively for the wind energy industry. These rugged yet simple devices consistently provide accurate wind speed and direction data. With a service interval of 10 years, you can rest assured that Hybrid turbine control sensors will perform as expected with minimal maintenance. Tens of thousands of NRG sensors are being used for turbine control around the world, including regions that experience the most extreme weather conditions in both hemispheres.

  • Buffered Analog Crosspoint Switches

    Analog Devices Inc.

    Analog Devices buffered video crosspoint switches offer multiple configurations from 8x8 up to 32x32 channels with gain of 1 or 2 and are offered in LQFP, LFCSP, and BGA packages. These crosspoint switches can be programmed either in serial or parallel modes and are used primarily for routing high speed signals, including composite video (NTSC, PAL, SECAM) and component video (YUV, RGB) in applications such as studios, video on demand, in-flight entertainment, surveillance, and video teleconferencing.

  • Premise Toner Drop Cable Continuity Tester

    RPT-AAA Series - Ripley Tools LLC

    Electronic testing tool designed to check the circuit integrity in new or installed cable up to 5,000 feet (1,500 meters) in length LED indicates DC shorts, splitters & other self-grounding devices in cable while a loud audio tone identifies the line carrying the signal Equipped with a right angle male push-on connector to maneuver in tight areas & a female push-on connector for speed toning Tool includes a pocket clip & (1) AAA 1.5V battery.

  • Single Head Component Testers

    34XX - FETservice, Inc

    Performs DC, AC, and pulsed tests. Excels at evaluating difficult to measure parameters on zeners, current limiters, varactor tuning diodes, darlingtons and matched dual transistors. 24 bin opto-isolated handler/prober interface. Parallel first-in first out computer to tester interface for maximum throughput. Parallel testing with a 3402E or 3403E allows shared test execution for extremely high throughput applications when interfaced to high speed handlers with multiple test sites.

  • Iifrasound Monitoring System

    INFRASONITUS - BioAge s.r.l.

    The infrasonic signal, acquired by a suitable microphone, is filtered by an active low-pass filter of the fifth order with a cut-off frequency at 20 Hz, with low noise, then it is sampled and acquired by a 16-bit ADC with a speed of 50 samples. / sec. The amplification factor can be set to 0.1 / 0.5 / 1/10.The infrasonic monitoring system includes a complete diagnostic functionality that performs an exhaustive functional test without the use of other tools: this function is extremely useful when the system is installed on the volcano at high altitudes.

  • Low Noise Op Amplifiers (≤ 10nV/√Hz)

    Analog Devices Inc.

    Analog Devices’ portfolio of low noise (≤ 10nV/√Hz) op amps includes many amps with the lowest noise performance in the industry. These high speed, low distortion (1 nV or less) op amps enable better signal fidelity in the most demanding conditions, allowing system designers to achieve the lowest total system noise performance in applications with high source impedances. We feature a considerable variety of these amps with wide supply ranges and low power.

  • Process Laser Gas Analyzer

    PLGA-1000 - HORIBA, Ltd.

    The PLGA-1000 Process Laser Gas Analyzer is designed to measure hydrocarbons and other gases contained in process gases at petrochemical plants. The PLGA-1000 uses proprietary technology to measure low concentrations of acetylene (C2H2) and carbon dioxide (CO2) contained as impurities in high concentration methane (CH4) and ethane (C2H6) which are material gases, continuously at high speed and with high sensitivity . This contributes to improvements in productivity, cost, and quality in the manufacturing process, as well as reducing environmental impact.

  • Digital I/O PXI Card

    GX5150 - Terotest Systems Ltd.

    The GX5150 Series are high speed, 6U PXI, sequenced digital I/O instruments. The GX5150 master controller has 32 bits of I/O channels that supports test rates of up to 50 MHz and a vector depth of up to 128 Mb per pin. The GX5151 slave offers the same timing characteristics and multiple I/O level configurations when used in conjunction with the GX5150. The GX5150 can control up to 15 GX5151 boards using the same timing and sequencer.

  • Inductive Measuring Probes

    Smartech Inc.

    • Inductive measuring probes specially designed for measurement by comparison• Available in 2 versions: spring push and pneumatic push• Long life precision bearing guidance (tested up to 13 million cycles)• Resolution <0.0001 mm• Repeatability 0.15 μm• Measuring range +/- 2mm and +/- 5 mm• Compatible with D300SV2, D70i and D400S units through M-Bus multiplexer units• High data speed• Operating temperature +10 to +80°C• IP65 protected

  • Automated Optical Inspection (AOI)

    TR7500 SII - Test Research, Inc.

    Featuring a large FOV 3-CCD color camera and four angled cameras, the TR7500 SII automated optical inspection offers double the scanning speed of TR7500 with identical inspection performance in an inline solution. The system is capable of high performance inspection at resolutions ranging from 10 to 15 µm, utilizing TRI' hallmark on-the-fly Dynamic Imaging technology for powerful pre/post reflow inspection without generating vibration associated with stop-and-go systems.

  • Universal PMICs

    MaxLinear

    PowerArchitect™ design and configuration software speeds development and significantly reduces overall time-to-market compared to legacy analog power solutions. An I²C interface and multiple GPIO pins ensure easy system integration. Configurable warning and fault levels, fault behavior and power up and down sequencing ensure any load can be properly powered and protected. The power system design can be completed with confidence long before the final revision of the SoC or ASIC is available.

  • VPX, OpenVPX Rugged Platforms

    ADLINK Technology Inc.

    The Versatile Performance Switching (VPX) standard, also known as VITA 46, defines Eurocard form factor systems supporting switched fabrics over a new high speed connector. Intended for embedded systems that meet the extremely harsh environments of military applications where size, weight, and power (SWaP) are critical, ADLINK's VPX line of commercial off-the-shelf (COTS) products enable fast deployment with reduced development burden and costs compared to proprietary systems.

  • PCI-8 AE Board

    Innerspec Technologies, Inc

    The PCI-8 is an 8-channel, PCI-based AE system on a board. Its 8 high-speed AE channels offer simultaneous AE data acquisition, waveform processing and data transfer. The board’s standard PCI form factor enables installation in standard PCs, as well as in any of Physical Acoustics’ specialized AE system chassis, while the PCI bus enables AE data transfer at speeds of up to 132 Mb/s, at a frequency range of 1 kHz to 400 kHz.

Get Help