Showing results: 1096 - 1110 of 1679 items found.
-
Teledyne RF & Microwave
With a 30 year YIG heritage, Teledyne RF & Microwave integrates YIG components with related microwave technologies, creating custom solutions that leverage the advantages of YIGs in cost-effective assemblies including synthesizers, receivers, converters and more.
-
M9362A-D01 -
Keysight Technologies
The Keysight M9362A-D01 PXIe is a wide bandwidth, multichannel downconverter in a small form factor. This microwave downconverter module slots into a Keysight PXI receiver and is ideal for applications where wideband signal capture of multiple channels is required.
-
188 FFF -
Standard Electric Works Co., Ltd
● The 188FFF doesn't have the function of the sensitivity adjustment. If the customers need the sensitivity adjustment function, plase refer to other models.● The 188FFF is a Fuse and Fault Finder which comprises of two parts : The Receiver and the Transmitter.● The Transmitter, draws a current from the mains supply circuit to which it is connected to. The Signal● Current from the Tx is at about 10kHz. The Transmitter is powered by the mains and requires no batteries.● The 10kHz signal current generated by the Transmitter is then searched(sniffed) by the Receiver to detect the Fuse, Circuit Breaker or the faulty circuit.● The Receiver is a tuned circuit which has it's center frequency tuned to about 10kHz. The sensor is located in the tip of the Receiver.● The amplitude of the received signal is shown on a bar-graph type Leds.● The more Leds ON, the stronger the signal.
-
Newport Electronics
High speed optical detectors use special photodiodes with high speed electronic circuits to convert fast optical pulses to electrical signals for measurement. Unlike our optical receivers, these detectors do not include a transimpedance amplifier.
-
310113494 -
Virginia Panel Corporation
The Rack Mount Extender Block Kit is used for mounting to racks with recessed mounting rails recessed more than 1.” It is made of aluminum with a black anodized finish. NOTE: Used only with slide mounted 9025TR Receivers.
-
310113406 -
Virginia Panel Corporation
The Rack Mount Extender Block Kit is used for mounting to racks with recessed mounting rails recessed more than 1.” It is made of aluminum with a black anodized finish. NOTE: Used only with slide mounted G12 Receivers.
-
310113548 -
Virginia Panel Corporation
The Rack Mount Extender Block Kit is used for mounting to racks with recessed mounting rails recessed more than 1”. It is made of aluminum with a black anodized finish. NOTE: Used only with slide mounted G12 Receivers.
-
310113519 -
Virginia Panel Corporation
The Rack Mount Extender Block Kit is used for mounting to racks with recessed mounting rails recessed more than 1.” It is made of aluminum with a black anodized finish. NOTE: Used only with slide mounted G12x Receivers.
-
TT&C -
L-3 Cincinnati Electronics
L3 Cincinnati Electronics (L3 CE) offers a variety of TT&C Receivers and Transmitters for various mission requirements. L3 CE can customize any of the products listed below to fit any mission command and telemetry needs.
-
V720 -
Highland Technology, Inc.
The V720 is a six-channel logic-level electrical-to-optical converter, packaged as a single-width, 6U VME module. It may be used with compatible Highland optical receiver modules for fast, low-jitter, EMI-proof distribution of pulses, triggers, and precision timing signals.
-
BroadSim Wavefront Software -
Safran Federal Systems
Protecting your GNSS systems from jamming and spoofing is more critical now than ever before. BroadSim Wavefront was designed to enable easier and more affordable CRPA receiver testing, leveraging proven software-defined architecture.
-
Virginia Panel Corporation
VPC rack mountable receivers like the 9025 meet the standards which are essential to support advanced mass interconnect requirements. Connector modules can be intermixed to establish custom interfaces which are ideal for functional and system testing applications.
-
WTEM-3Q -
Langeo Co., Ltd.
WTEM-3Q time-domain shallow transient electromagnetic sounding system is our latest equipment developed for magnetic survey by TEM method, which integrated with WTEM-1J/GPS TEM system receiver and WTEM-1X low-power TEM system transmitter.
-
TECHNO-AC
The most advanced locating kit combining the functions of three devices: cable locator, water leak detector, non-metal pipe locator. Features AP-027 receiver, powerful transmitter and special impact device for the detection of non-metal pipelines.
-
PCIe-Mini-COM-8 -
ALPHI Technology Corporation
The PCIe-Mini-COM-8 is an 8-channel PCI Express (PCIe) UART (Universal Asynchronous Receiver and Transmitter) optimized for higher performance. The PCIe-Mini-COM-8 serves as a single lane PCIe bridge to 8 independent enhanced 16550 compatible UARTs.