Showing results: 151 - 165 of 273 items found.
-
119EXT3024-37XXR -
ELMA Electronic, Inc.
VPX Test Extender 3U 240mm for conduction cooled boards in convection chassis
-
119EXT3024-27XXR -
ELMA Electronic, Inc.
VPX Test Extender 3U 240mm for conduction cooled boards in conduction cooled chassis
-
S95560B -
Keysight Technologies
banded vector network analyzer (VNA) using the M980xA PXI VNAs and N5252AW or N5262BW Frequency Extenders.
-
CF extend 182 -
Sycard Technology
The CF extend 182 is a low profile flexible extender card designed to physically extend the CompactFlash™ socket for easy access. Similar to Sycard's CF extend 180, the model 182 reduces the overall dimensions of the extender by using a single piece flexible circuit board. The lower profile allows for uses in many applications where the CF extend 180 was too bulky. The CF extend 182 extends the CompactFlash socket 5".
-
STG-06-S1 -
ERAVANT
Full band noise figure and gain test extenders are offered to extend noise and gain measuring capabilities up to higher millimeterwave frequency ranges. These extenders are designed to interface with noise and gain test systems that have an input IF of 10 MHz to 1.6 GHz, such as the industry standard Keysight 8970A/B, N8975A and Maury MT 2075B. The noise figure and gain test extenders include a high-performance, solid-state noise source (STZ series) and a full waveguide down converter (STC series), which consists of a Faraday isolator (STF series), full band mixer (SFB series), frequency multiplier, and IF amplifier. A frequency source with an output signal in the frequency range of 10 to 20 GHz is required as a local oscillator for the down converter. The noise source is automatically powered on and off by the noise figure meter.
-
116FFE6006-012X -
ELMA Electronic, Inc.
the VME64x form factor extender 6U 60 mm allows to adapt boards for use in the same VMEbus system. It maintain the correct depth dimensions and allow the front panel to be aligned.
-
N5295AX02 -
Keysight Technologies
The N5295AX02 is a compact and broadband frequency extender with built-in pulsed bias-tee and provides 10 MHz to 120 GHz single-sweep measurements with N5292A test set controller systemized with a PNA/PNA-X B vector network analyzer.
-
N5293AX02 -
Keysight Technologies
The N5293AX02 is a compact and broadband frequency extender with built-in pulsed bias-tee and provides 10 MHz to 110 GHz single-sweep measurements with N5292A test set controller systemized with a PNA/PNA-X B vector network analyzer.
-
N5295AX52 -
Keysight Technologies
The N5295AX52 is a compact and broadband frequency extender with built-in pulsed bias-tee and provides 10 MHz to 120 GHz single-sweep measurements with N5292A test set controller systemized with a PNA/PNA-X B vector network analyzer.
-
116EXT6122-012XR -
ELMA Electronic, Inc.
The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.
-
N5293AX52 -
Keysight Technologies
The Keysight N5293AX52 is a broadband frequency extension module designed for use with Keysight’s new PNA / PNA-X-based millimeter-wave solutions. It is a compact, lightweight, and ruggedize frequency extender module with built-in bias tee for pulsed DC bias operation. It interfaces with the Keysight N5292A test set controller. The modules allow users to extend the frequency coverage of a base PNA / PNA-X Series network analyzers to a range of 10 MHz to 110 GHz. For more information about cable and accessories for use with network analyzers, please visit Network Analyzer Accessories.
-
3954 -
Technobox, Inc.
The extender/analysis probe permits extension of a PMC card beyong the edge of a host processor front panel, providing access to both Side 1 and Side 2 of a PMC under test.
-
S97560B -
Keysight Technologies
Configure an affordable millimeter-wave banded VNA using P50xxA Streamline USB VNAs with this software
-
-
ST-C6HDE-HDBT -
Network Technologies Inc
The XTENDEX® HDMI HDBase-T Extender transmits uncompressed digital HDMI signal, IR, RS232, and Ethernet up to 328 feet over a single CAT5e/6/7 cable using HDBase-T technology. Each video extender consists of a local unit that connects to an HDMI source and a remote unit that connects to an HDMI display.