Showing results: 136 - 150 of 272 items found.
-
310113548 -
Virginia Panel Corporation
The Rack Mount Extender Block Kit is used for mounting to racks with recessed mounting rails recessed more than 1”. It is made of aluminum with a black anodized finish. NOTE: Used only with slide mounted G12 Receivers.
-
310113519 -
Virginia Panel Corporation
The Rack Mount Extender Block Kit is used for mounting to racks with recessed mounting rails recessed more than 1.” It is made of aluminum with a black anodized finish. NOTE: Used only with slide mounted G12x Receivers.
-
116EXT6122-0125R -
ELMA Electronic, Inc.
The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.
-
111EXT9122-0120 -
ELMA Electronic, Inc.
The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.
-
ELMA Electronic, Inc.
The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.
-
111EXT9140-0120 -
ELMA Electronic, Inc.
The VME extender boards are designed to bring a circuit card completely out of a card cage so that it can be tested or debugged on both sides of the test board. Each signal, power, and ground line can be individually isolated with the DIP switches.
-
PCCextend 120 -
Sycard Technology
The PCCextend 120 is a flexible extender card designed to provide easy access to a 16-bit PC Card for debug or test. Designed with the same low noise characteristics of our PCCextend 100, the PCCextend 120 takes this design a step further by connecting the host and card via ribbon cables.
-
IP-Debug-Bus -
Dynamic Engineering
IP-Debug-Bus is a specialized extender card which is optimized for testing IP Modules. The bus signals are all accessible via test points. The testpoints include multiple ground locations and .025 sq. posts for ease of connection to your logic analyzer or scope. The testpoints are labeled for easy identification
-
SKU-013-0X -
Amfeltec Corp.
The PCI-to-PMC Extender was designed to convert any standard PCI slot of a PC to a PMC (PCI Mezzanine Card) slot. It allows a standard personal computer to be used as a testing/development platform for PMC interface cards. The adapter allows easy access to the PCI (PMC) logic signals, overcurrent protection and hot-swap capability.
-
FO-1553 -
Avionics Interface Technologies
Extends MIL-STD-1553 bus access to over 1 mile for remote access - Dual redundant, single and dual stream options available - Both Transformer and Direct coupling modes supported - Uses fiber optic 1.0625 Gbps data rates for low latency over long distances - Optical signaling is not affected by electrical noise and interference - Simple and easy to use solution, no software setup or configuration required - Ideal for applications where test equipment is separated from UUT
-
PCI EmbeddedComputer Systems
This adapter can be used to run, test or program a 3U VPX card in a standard PC PCIe slot. SSC switchable (ON/OFF) PCs available from PCI-Systems Inc.
-
PCCextend 50 -
Sycard Technology
In a high volume production environment a PCCtest socket tester may see several thousand insertion/removal cycles a month. To prevent wear and tear on the PCCtest's 68-pin connector, Sycard supplies a low cost "socket saver", the PCCextend 50. The PCCextend 50 is inserted between the 16-bit PC Card socket and the PCCtest unit.
-
CF extend 162 -
Sycard Technology
In a high volume production environment a CF test 220 socket tester may see several thousand insertion/removal cycles a month. To prevent wear and tear on the CF test 220's 50-pin connector, Sycard supplies a low-cost socket saver, the CFextend 162. The CF extend 162 is inserted between the CompactFlash™ socket and the CF test 220 unit.
-
-
119EXT3024-37XXR -
ELMA Electronic, Inc.
VPX Test Extender 3U 240mm for conduction cooled boards in convection chassis