Showing results: 436 - 450 of 2564 items found.
-
ADSE 743 -
ATEQ Aviation
The ADSE 743 caters fully for all aircraft types and the different electrical power supplies.
-
-
-
-
-
OAT -
UMA, Inc.
The outside air temperature sensor is an electrical component that complements the control of a modern heating system.
-
Model 4801 -
Pentek, Inc.
- Pin definitions and electrical specifications of all signals on the module- 3D models of the module- Thermal profiles of the module and components- Carrier reference design schematics- PCB stack-up recommendations- PCB design guidelines and routing rules- Operating systems and bootstrap guidelines- Additional electrical and mechanical engineering guidance
-
Positek Limited
Intrinsically Safe systems provide a safe operating environment for personnel and equipment. Intrinsic Safety (IS) is based on the principle of restricting the electrical energy transmitted into a hazardous area, thereby ensuring that anysparks or heated surfaces that may occur as a result of electrical failures areinsufficient to cause ignition. The threat of an explosion is eliminated.
-
Weice Testing Instrument Co.,Ltd.
The WTS series of salt spray chambers are manufactured and designed to meet the high quality requirements and standards, such as ISO, JIS, DIN, ASTM, IEC, GB and SAE. They are used to test the resistance capabilities of materials eroded by brine, these materials may be used in Electrical Appliances, Electrical Wire, Accessories, Luminaires etc.
-
PeakTech Prüf- und Messtechnik GmbH
Current clamps are ideal for current measurement in electrical systems and control cabinets, since only single wires are guided through the clamp jaws for contact-free current measurement and no electrical connections have to be disconnected. In addition, this model has extensive multimeter functions for voltage, resistance, frequency, capacitance and temperature measurement.
-
Aarohi Embedded Systems Pvt. Ltd
Aarohi make device enable us to measure electrical leakage in wire, results are very reliable as we shall be passing electric current through device while we are testing. The equipment basically uses for verifying the electrical insulation level of any device such as motors, cables, generators, windings, etc.
-
-
SDL Atlas
is a transducer that is used to create an electrical signal whose magnitude is directly proportional to the force being measured.
-
MRC ltd.
Measures low resistance to detect faulty connections that degrade electrical system performance.Prevent electronic failures.
-
Entes Elektronik
ENTES Multimeters are designed to measure the electrical parameters such as current, voltage, frequency and cos in industrial plants.