Showing results: 856 - 870 of 1390 items found.
-
PAS 9782/GEN -
Precision Analog Systems Co.
The PAS 9782/GEN is a VME based, eight channel function generator card. Each channel contains a Direct Digital Synthesis (DDS) chip that can be programmed to generate sine wave output signals. This DDS device is a Numerically Controlled Oscillator (NCO), employing a phase accumulator, a sine look-up table and a 10 bit D/A converter.
-
PAS 9883/GEN -
Precision Analog Systems Co.
The PAS 9883/GEN is a VME based, eight channel function generator card. Each channel contains a Direct Digital Synthesis (DDS) chip that can be programmed to generate sine wave output signals. This DDS device is a Numerically Controlled Oscillator (NCO), employing a phase accumulator, a sine look-up table and a 10 bit D/A converter.
-
781909-01 -
NI
20 MHz Bandwidth, 400 MHz to 4.4 GHz Software Defined Radio Device - The USRP‑2922 is a tunable RF transceiver with a high-speed analog‑to‑digital converter and digital‑to‑analog converter for streaming baseband I and Q signals to a host PC over 1 Gigabit Ethernet. You can also use the USRP‑2922 for the following communications applications: WiFi, WiMax, S‑band transceivers, and 2.4 GHz industrial, scientific, and medical (ISM) band transceivers.
-
HDR -
Computer Conversions Corporation
The HDR Series are sub-miniature modules that are; size comparable, low cost alternatives to Hybrid type D-R and D-S converters. Because of their advanced modular design the HDRL series features short lead times that are neither limited to infrequent hybrid production cycles, long term parts allocation, minimum quantity purchases, or hybrid obsolescence related concerns.
-
PCI3IP -
Dynamic Engineering
The PCI compatible PCI3IP design adds 3 Industrypack compatible slots to your PCI host. The PCI3IP acts as an adapter, converter, carrier, or bridge between the PCI bus and your IndustryPack hardware. The PCI3IP is a half size PCI card with 3 IP sites; compatible with the smallest chassis and the tallest processors that prevent full size solutions.
-
PCIeBPMCX1 -
Dynamic Engineering
Now you can use your PMC with a new PC. The new PC´s have PCI Express connectors in larger quantities than PCI slots. The PCIeBPMCX1 ( PCIe Bridge PMC 1 slot) adapter / carrier converter card provides the ability to install one PMC card into a standard PCIe (Express) 4 lane slot.
-
PSI -
Computer Conversions Corporation
Computer Conversions Solid State Selsyn/Resolver Indicator digitizes the outputs of Selsyns, Synchros and Resolvers for position indication and control applications. The Selsyn Indicator is designed to replace failure prone mechanical selsyn torque receivers, counters, etc. The tracking converters high noise immunity and high speed tracking characteristics make it ideal for use in industrial envrionments.
-
Monarch Instrument
Monarch offers a full range of products to cover your speed recording needs. From our ACT series panel tachometers and Frequency to Analog converters with PC Software to our Data Chart paperless recorders. All of our products interface directly with our speed sensors to provide you with a complete solution for your application.
-
Model 22NX -
Telebyte, Inc.
FEATURES: Triple Stage Protection; Fast Response Time For RS-422 / RS-485; Prevents Damage to Modems, Converters, and Terminals; Accommodates Data Rates to 10 MBPS; Supports 4 Circuits. The Model 22NX Lightning Sponge is designed to accommodate high-voltage transients, slow them down and redirect them to a low impedance path to earth ground.
-
PCI-AI12-16(A) -
Acces I/O Products, Inc.
Model PCI-AI12-16 is a multifunction, high-speed, analog-to-digital converter board for use in PCI-Bus computers. It accepts up to 16 single-ended or eight differential inputs. The board uses a low-noise, multilayer printed circuit board. Inputs are protected against overvoltage conditions up to ±35 volts and typically survive static discharges beyond 4000 volts.
-
LYNXEA_VIS -
AUREA Technology
The LynXea_VIS from AUREA Technology is a stand-alone [400-1060 nm] Time Correlated Single Photon Counting TCSPC module, which fully integrates the Time to Digital Converter and the best single photon avalanche detection (SPAD) counting technologies within the same box. As a matter of fact, TCSPC measurements are now available without assembling multiple boxes!
-
DP-VME-1427 -
Data Patterns Pvt. Ltd.
The DP-VME-1427 is a standard 6U VME based general purpose 32 channel Analog to Digital Convertor (ADC) module. The module is a slave VME 64x interface, that responds to A24/D16 standard VME address cycle. On-board auto-conversion circuitry performs all the task related to multiplexing, sampling and converting of analog input signals to the digital outputs.
-
PMC230A -
Acromag, Inc.
PMC230A modules have eight 16-bit D/A converter (DACs) to provide highly-accurate analog voltage outputs. A unique two-piece board design brings the proven reliability of Acromag’s IndustryPack® (IP) A/D modules to a PMC format. An IP230A module is embedded on a PMC interface card that maintains maximum performance and transparent communication to the host.
-
PCI-AI12-16A -
Acces I/O Products, Inc.
Model PCI-AI12-16 is a multifunction, high-speed, analog-to-digital converter board for use in PCI-Bus computers. It accepts up to 16 single-ended or eight differential inputs. The board uses a low-noise, multilayer printed circuit board. Inputs are protected against overvoltage conditions up to ±35 volts and typically survive static discharges beyond 4000 volts.
-
Copper Mountain Technologies
This impedance matching pad is a lab grade tool used in RF and microwave matching to adapt 50 Ohm impedance to 75 Ohm impedance. It is used in measurement setups that require impedance conversion with low VSWR. The 8AP50NM75NF Impedance Matching Pad is a 50 Ohm – 75 Ohm or 75 Ohm – 50 Ohm impedance converter with type-N connectors.