Showing results: 826 - 840 of 2637 items found.
-
FLIR VP50-2 -
Teledyne FLIR
The FLIR VP50-2 is a durable, CAT IV-rated non-contact voltage detector featuring light, vibration, and beeper feedback alarms and a powerful LED flashlight. Use the VP50-2 to reliably check if an AC circuit is live before beginning work; detect voltage on exposed conducting parts or through insulation; identify live wires within electrical panels, switches, and outlets; or trace live wires and map circuits. With an ergonomic and drop-tested design, the FLIR VP50-2 is the right choice for professionals performing field troubleshooting and verification of electrical installations within residential, commercial, and industrial buildings.
-
PCE Instruments
With certain models of cable detectors you can locate open power cables, either live or dead (without current), with voltages up to 300V. Cable detectors can locate cables, circuits, short circuits and ground points. To perform these functions, it is not necessary to disconnect electrically sensitive devices or to disconnect theCable Detectors to locate open power cables, either live or without current, up to 300V power from the cable which is being tested. Cable detectors can also locate ferrous and non-ferrous metals, wood and plastic with a high level of accuracy.
-
Panasonic Automotive & Industrial Systems Europe GmbH
Main unit expandable with up to 3 expansion unitsEach unit can measure up to 2 circuits (8 circuits with 3 expansion units)Accuracy: 0.2% for V, I and 0.5% for kWhPower quality measurements (THD and harmonic analysis up to the 31st order)Bidirectional energy measurement (energy produced and energy consumed)Demand measurementWeb server functionality integratedNo hub switch required2 Ethernet ports, 1 RS485 interface1 input, 2 outputsHour meter functionalityDIN rail mountingQuick wiring thanks to push-in terminalsIEC61010-1 CAT III
-
TMR9112 -
MultiDimension Technology Co.,Ltd.
The TMR9112 demo board was developed to support evalution of the TMR9112 single-axis sensor. The demo board comes with the fast bipolar current pulsing circuit needed for initialising the TMR9112 sensor, and it can be powered from a USB port or any external 5V power supply. For user convenience, the demo board has an optional on-board timer clock with four selectable frequency settings. The On-board timer clock and frequency output can be enabled using the jumper pins. This demo board is divisable along the dotted line so that the sensor board can be seperated from the pulsing circuit board.
-
69600 -
Lisle Corp.
Kit includes 14 flexible test probes, long straight probe, piercing back probe, crocodile clip, 4mm circuit tester adapter and Deutsch spooned probe. The probes are designed to be used on popular Weather-Pack, Metri-Pack and Micro-Pack style connectors. The test probes are 5" in length and are flexible to help eliminate damage to the connector terminals that can result from testing with a standard test probe. The 4mm adapter allows conversion of some circuit testers to a 4mm banana connector, which provides a better connection. Kit comes in a pouch for storage.
-
CD15 -
Validyne Engineering
The CD15 Sine Wave Carrier Demodulator operates with variable reluctance transducers to provide a DC output signal for dynamics as well as steady state measurements. A 5kHz sine wave excitation is applied to the two inductance ratio arms of the transducer and the resulting output is demodulated and amplified using the latest integrated circuit techniques. The DC output is obtained from an active filter circuit and gives a uniform response from steady state to 1000 Hz. The low impedance sine wave excitation allows operation with the transducer located over 1,000 feet from the CD15.
-
165 -
Electronic Specialties Inc.
Starter Buddy tests the health of the vehicle’s electrical starting/cranking circuit. Slow cranks and no cranks are most likely caused by excessive voltage drops (resistance). If excessive resistance exists, Starter Buddy will help you quickly locate and diagnose which part of the circuit has the issue. Just 3 connections and a 3 second cranking test diagnose the problem. 12 foot test leads allow safe connections and control of the cranking test from the driver’s seat. Starter Buddy includes a training DVD with three 15 min videos by Dan Sullivan.
-
MicroContact AG
MCA-ST connector adapter for the connection of micro plugThe connector adapter allows the direct connection of fine-pole connectors on circuit carriers or jumpers. The adapter is guided over the connector housing, which overcomes the tolerances of carrier and mounting.
-
Renesas Electronics Corp.
DC input/single transistor output photocouplers (optocouplers) are optically coupled isolators containing a GaAs infrared light emitting diode and an NPN silicon phototransistor. This type is suitable for applications such as I/O interfaces and signal transmission circuits.
-
Vogelsang & Benning
Test bench for electric machines and inverters in hybrid applications*Control of mechanical parameters*Verification of electrical properties*Checking the LL characteristics*Short circuit measurement*Recording the performance process*Noise measurement*Temperature measurement
-
M7 -
Seismic Source Co.
*Dual independent Accelerometers for Quality Assurance*Protected against electromagnetic interference (EMI)*Protected against moisture*Input polarity protected*Output short circuit protected*Withstands up to 2000 g's without damage
-
CYHCT-WS3 -
ChenYang Technologies GmbH & Co. KG
The sensor CYHCT-WS3 is a Hall Effect sensor for the measurement of DC current. The sensor has agalvanic isolation between the high power primary conductor and the secondary electronic circuit and withdifferent output signals and different power supplies.
-
SHS1000 Series -
SIGLENT Technologies
Siglent’s SHS1000-series handheld digital oscilloscopes take advantage of years of SIGLENT research and development. It adopts many dedicated integrated circuits which allows for a simpler layout, low power consumption and a very small footprint.
-
Quick Draw II -
Bounty Hunter
The Quick Draw II is equipped with a powerful Micro-chip Computer Circuit, which combines with Bounty Hunter's Patented Technology to offer more features, performance and value than any other detector in its price range.
-
99539 -
DL Instruments, LLC
The Model 99539 is a modular, multi-channel current preamplifier with parallel, logic level, gain control input. It consists of circuit boards which plug into a 3 1/2" high by 19" wide rack chassis.