Showing results: 286 - 300 of 741 items found.
-
HD-500 -
Matrix Test Equipment Incorporated
The MATRIX Model HD-500 is a detector-amplifier designed to demodulate the low frequency amplitude modulations on any RF carrier over the range of 5 to 1500 MHz. These modulations are usually the undesirable result of the 50 or 60 Hz power source and are not necessarily sinusoidal. The unit is calibrated to the SCTE definition of hum modulation, which is the ratio of the peak-to-peak hum modulation to the peak of the carrier.
-
ProDAQ 3202 -
Bustec Ltd.
The ProDAQ 3202 voltage reference card is used in the ProDAQ 3180 ultra-performance motherboards and LXI function card carriers. The ProDAQ 3202 voltage reference card is plugged directly onto the motherboard or carrier and can distribute the reference voltage to all ProDAQ function cards via two signal lines. This allows the distribution as a differential signal to overcome possible noise pick-up.
-
LF (125 kHz) -
Balluff GmbH
BIS L uses a low frequency (LF) of 125 kHz with passive data carriers. These data carriers are read/write, designed for use in harsh environments and chemically highly resistant. With BIS L you can handle applications with special demands economically. Small form factors and versions with enhanced data security (additional check code) also provide great flexibility.
-
ProDAQ 6210 -
Bustec Ltd.
The ProDAQ 6210 19-inch rack-mount tray allows users to install up to two ProDAQ 6100 LXI function card carriers in a standard, 19-inch rack. With the ProDAQ 6100 installed in an LXI function card carrier, the ProDAQ 6210 uses no more than 1U space. Adjustable rear supports ensure that the tray can be installed in most 19-inch racks.
-
GL Communications Inc.
T1/E1 carriers are used extensively throughout the world for carrying large volumes of call containing both voice and data. Their popularity can be attributed to their high reliability, manageability and flexibility. The available digitized channels, 24 for T1 and 32 for E1 can be used for carrying voice and/or data. Further, the carriers can be used separately or they can be combined in order to provide higher transmission bandwidth.
-
SMT835-ZU47DR-2 -
Sundance Multiprocessor Technology Ltd.
The Sundance SMT835-ZU47DR-2 is a PCI express ZynqRF system comprised of the TEB0805 carrier board and the TE0835-02-TXE21-A RFSoC module.
-
AVC429-x -
AIM GmbH
Integrated modular solution by using the AMCX429-x PMC cards installed on AIM’s AVC-2 Generic VME64x (6U) carrier card.
-
Advantech Co. Ltd.
Advantech development kits includes a series of carrier boards and starter kits with schematic software and reference design to accelerate evaluation.
-
8100 -
ELMA Electronic, Inc.
The metering PMC to PMC extender is a comprehensive development tool for use with PMC cards on a VMEbus, Compact PCI, or other carrier card.
-
PMC -
PCI EmbeddedComputer Systems
The PMC test extender provides an active interface between a PMC carrier slot (PCI bus) and a PCI Mezzanine Card (PMC).
-
PCIe3IP -
Dynamic Engineering
IndustryPack® Modules are an important part of solutions for Embedded situations. Rugged, small, light ... just right for many applications. IndustryPack® Modules require a carrier to adapt them to the system. Dynamic Engineering has carrier solutions for a variety of formats. PCIe3IP is designed to support PC computer based solutions. Solutions available for PCI, PC104p, cPCI, VPX and planned for cPCIexpress, PC104e.
-
NI
The Matrix Module for SwitchBlock is for use with the PXI Carrier Module for SwitchBlock and can operate as an individual relay card, can combine with other Matrix Modules for SwitchBlock in the same PXI Carrier Module for SwitchBlock, and can combine with other Matrix Modules for SwitchBlock in other PXI Carrier Modules for SwitchBlock in the same PXI chassis. Each Matrix Module for SwitchBlock comes in an A-type version, which serves as the first matrix building block and offers row and column access through the front connector, and a B-type version, which serves as an expansion module and only provides column access through the front connector. Typically, SwitchBlock systems contain one A-type module and numerous B-type modules.
-
NES-FMC-CAN -
Sundance Multiprocessor Technology Ltd.
This is a Dual or Quad CANbus with autotest capabilities that can be used on a wide range of carriers, Standalone, PCIExpress, CompactPCI, VPX, CompactPCI Express, AdvanceTCA and AMC.
-
ProDAQ 3410 -
Bustec Ltd.
The ProDAQ 3410 input-protected ADC function card is a ProDAQ high-density card that fits into ProDAQ VXIbus motherboards and LXI function card carriers.
-
Cyxtera Technologies
The data center is the nexus of the modern enterprise. Instantly connect with a diverse marketplace of network carriers and leading cloud providers for your hybrid IT infrastructure