Filter Results By:

Products

Applications

Manufacturers

Showing results: 46 - 50 of 50 items found.

  • 500 AMP Carbon Pile Load Tester

    710 - Electronic Specialties Inc.

    The #710 will perform variable load testing on 12 volt batteries rated as high as 1000 Cold Cranking Amps. Use this battery tester to simulate actual cranking loads. Also tests alternator charging voltage and relative starter current draw. The #710 features large dual meters to display the battery voltage and load current simultaneously, during the test.

  • 6/12/24/36V Conductance Battery Tester

    MBT300 - Matco Tools

    Tests 6/12/24V lead acid batteries individually or in parallel and series battery packs. Displays battery or battery pack condition as % available capacity, rated capacity (CCAs), state of charge voltage, and good or replace status. Tests 6/12/24/36V starter and charging systems including starter draw, alternator and regulator output (loaded/unloaded), and diode ripple.

  • Tester for Voltage Regulators

    MS012 COM - MSG Equipment

    The device simulates installation of voltage regulator on faultless alternator in order to test its operating performance under different loads and modes, under various rotor resistance parameters. The handset tester conducts diagnostics of all existing types and models of voltage regulators.New types and models of voltage regulators can easily be added by updating software through USB-port. The equipmentis controlledby three encoders and a sensor on colored display. Diagnostics lasts about 2 minutes.

  • CTEK Smartpass 120 Power Management

    40-185 - CTEK Power USA

    SMARTPASS 120  is a fully automatic 120A power management system that prioritizes, controls and maximizes energy from your alternator to power your service battery. It safely separates your starter and service batteries automatically. It also distributes power between the starter battery, the service battery and on board equipment without the need for traditional diodes or VSR relays. This means that SMARTPASS 120 can make sure that critical functions like starters, radios, emergency lights and communication systems always have the power they need, and take priority over noncritical functions. SMARTPASS 120 works with any 12V lead acid battery. It can also be used with the CTEK D250SA 20A on board charger for the ultimate 140A power management system.

  • Battery Monitor

    BAF-M2 - Schumacher Electric Corporation

    BATTERY MONITOR• Plugs into a 12 volt automotive cigarette lighter receptacle• Allows instant monitoring of battery & charging system voltage• Constant automotive battery and charging system check with a digital readout• LED warning lights alert you when your battery or charging system is not functioning properly• Detects charging input voltage within 0.1 volts variance• Detects problems with the alternator, diode and any variance of more than 0.8 volts• Alerts you once battery drops to 12.0 volts giving you approximately one more hour of run time, depending on the system’s wattage• Digital display indicates electrical voltage of your battery• Mounted display on your car’s dashboard for constant monitoring of your electrical system Contents: (1) Battery Monitor with 12V DC plug

Get Help