-
Product
Conducted Immunity Test System
-
Conducted RF immunity tests acc. to IEC/EN61000-4-6 and BCI tests acc. to ISO 11452-4 and MIL-STD 461 CS 114 Signal generator,RF-power amplifier, RF-power meter and directional coupler (optional) in one 19”-caseStand-alone operation possible with optional available netbookControl-software includedMost important parameters are shown on an integrated displayAutomatic EUT-monitoringOperation via USB port of a PC or NotebookComplete range of CDNs available
-
Product
Dynamic Digital I/O With Per Channel Timing, Programmable Logic Levels And PMU PXI Card
GX5296
-
The GX5296 offers advanced dynamic digital I/O performance and capabilities in a single slot, 3U PXI format. The 32-channel, GX5296 features timing per pin, multiple time sets, data formatting, and an advanced sequencer – providing users with the capability to emulate and test complex digital busses for system, board or device test applications. Offering sub-nanosecond edge placement resolution per pin and a PMU per pin, the GX5296 has the ability to perform both DC and AC parametric testing. Each digital channel can be individually programmed for a drive hi, drive lo, sense hi, sense lo, and load value (with commutation voltage level). In addition, each channel offers a parametric measurement unit (PMU) providing users with the capability to perform parallel DC measurements on the DUT (device under test).
-
Product
Navigation Information System
Nav-IS
-
Aeronautical & General Instruments Ltd.
Nav-IS combines a single or dual axis EM Speed Log with a range of Meteorological System options for a low cost, integrated solution. Using the latest proven and in service solid state sensor technology, this innovative, cost-effective and accurate system has been specifically developed for all applications from ocean-going merchant and passenger vessels to offshore patrol, coastguard and naval support vessels.
-
Product
Direction Finding Systems
-
WiNRADiO Direction Finding systems are being used in some of the most adverse environments. We use proven and reliable DF techniques, all delivered fully integrated in ruggedized packaging, suitable for both mobile and stationary deployment.
-
Product
Video Quality Testing and Monitoring System
Net-Mozaic
-
The Net-MOZAIC can be used as a stand alone product or an integral part of our Net-xTVMS system. The Net-MOZAIC is normally located at the Head End with access to unencrypted TV channels. Customers define groups of 16 channels at the time. They are then decoded and analyzed for picture quality. Hundreds of channels can be analyzed this way on the round robbin.
-
Product
Stationary Meter Test Systems AC
-
Today Meter Test Technology is much more than only testing accuracy and functionality of a conventional electricity meters. With implementation of SmartMeters a complex test and data management system is required. – It’s a good thing to have experts by your side.
-
Product
Industrial CT X-Ray Inspection System
X7000
-
The X7000 is North Star Imaging’s largest standard system. The large scanning envelope and generous focal distance allow for unparalleled inspection capabilities of very large objects. The system is great for composites, castings, pipes, tubes, welds and similar parts.
-
Product
COM Express Embedded System – CM07
AS-CM07-CME-A
-
The CM07 COM Express Embedded System has been custom designed for a specific medical application in the field of radiation therapy. This unit integrates many features and interfaces which dramatically reduced the size compared with previous PC server based solution, as well as significantly increasing reliability.
-
Product
Analysis System
Trident (EDS-EBSD-WDS)
-
The Trident Analysis System combines the latest advances in Energy Dispersive Spectroscopy (EDS), Electron Backscatter Diffraction (EBSD), and Wavelength Dispersive Spectrometry (WDS) in a single analytical tool. With the Smart Features included in the easy to use EDAX analysis software, each technique can be optimized and used independently or they can be combined to provide seamless integration, resulting in comprehensive data collection that can then be shared between the different techniques.
-
Product
EMI Test System
EMI-9KA
-
EMI-9KA is an automatic EMI receiver. It is a main test system for EMI (Electro Magnetic Interference) testing. The EMI-9KA is produced by the full closure structure and strong electro-conductibility material, which has high shielding effect. Due to the new technology for the EMI Test System, it solved the instrument self-EMI problem. The test results are according to the international format test report. The EMI Test System EMI-9KA fully meets CISPRl6-1, GB17743, FCC, EN55015 and EN55022.
-
Product
Color Screen Sound Level Meter
AWA6228+
-
Hangzhou Aihua Instruments Co., Ltd.
Model AWA6228+ Sound level meter is a new generation noise measurement instrument developed with digital signal processing technology, which is up-to-data product of AWA6228 series.
-
Product
Level Switch
Z-Tron IV
-
The Z-Tron IV level switch is one of our most popular on/off level switches offering an effective, low-cost material level detection in a wide variety of applications. It is widely used as an alternative to electromechanical level switches.
-
Product
X-Ray Inspection System
MXI Quadra 5
-
Quadra™ 5 is the X-ray inspection system of choice for sub micron applications such as PCB and semiconductor package inspection, counterfeit component screening and finished goods quality control.
-
Product
Multiparameter Measuring Systems
-
With the Modulyzer measuring systems you can obtain multiple parameters from one sample in only one measuring cycle. Combined with Anton Paar sample changers you can even analyze a multitude of samples in fully-automatic, single-run mode. Select from pre-configured but modular options for your specific industry and application. Anton Paar’s Modulyzer measuring system setups are as individual as your requirements. No matter how many instruments you integrate in your individual configuration, Modulyzer is operated via only one screen and delivers all the results you need at the push of a button.
-
Product
Read-Write Analyzer Systems
4000 TDMR Series
-
For Two Dimensional Magnetic Recording (TDMR). The 4000 Series RWA Systems support UP12 preamplifier and the next generation front end cartridge/head amplifier designs on Guzik spinstands. Previous generation of head amplifiers together with UP11M are also supported by RWA-4000 TDMR Systems in one channel mode.
-
Product
Health Physics Systems
-
Detection and quantification of radioactive material within the body is a key factor in determining internal personnel contamination and dose assessment. These measurements can be made on body fluid samples using lab instrumentation or through direct measurement of personnel. The measurement of body fluids is generally less attractive due to the bio-hazards and lack of immediate results unless non-gamma emitting nuclide measurements are required. The direct measurement of personnel for gamma emitting radioactive material provides rapid results, can determine where the material may be located within the body, and does not require mobility of the material through body fluids for detection.
-
Product
ATE Test Systems
-
Introducing the Procyon ATE System! When it comes to ATE Test Systems for a for low- to high-volume production, Intepro has the testing power you require to be successful. For more than three decades, Intepro Systems has designed, built and integrated power supply test equipment for the world’s largest and smallest power supply manufacturers.
-
Product
MPI Manual Probe Systems
-
MPI Advanced Semiconductor Test
manual probe systems are open, easy to use and cost effective yet highly accurate. These systems are designed for precision analysis of substrates and wafers up to 150, 200 and 300mm.
-
Product
Deep-Well Level Probe
NTB Series
-
The KOBOLD NTB Series deep-well level probe offers a cost-effective solution for hydrostatic level measuring in wells, reservoirs, clarification plants and other water-holding vessels. It is easy to install and ideally suited for monitoring and protecting submersible pumps in deep water wells. The slim, 22mm-diameter level probe is perfect for tight applications.
-
Product
Standalone Test System
1000 Series ATE
-
The Circuit Check 1000 Series ATE provides a configurable standard platform that can utilize multiple mass interconnect interfaces while providing ease of maintenance and the ability to accept a wide variety of test fixture solutions. With the 1000 Series ATE, test procedures become automatic, with test steps and go/no-go limits easily programmable.
-
Product
Flexible Test System Automation Platform
RF2000A
-
The Ranatec RF2000A is a flexible test system automation platform that helps you to integrate your complete test system into a single box. No more cables and discrete parts on your desktop!
-
Product
Small Drop Test System
KRD41 series
-
KRD41 series small drop tester is suitable for free-fall test of small consumer electronics and components such as mobile phones, walkie-talkies, electronic dictionaries, CD / MD / MP3 and so on, applicable standards JISC 0044 and IEC 60068-2-32. Through standard tests on electronic products (surface drop, corner drop, edge drop, etc.) and collecting data, it simulates the vertical drop impact of electronic products during transportation and handling. It provides a basis for the design of the product's buffer and vibration damping and the selection of structural materials.
-
Product
Analysis System
Neptune (EDS-WDS)
-
By integrating Energy Dispersive Spectroscopy (EDS) and Wavelength Dispersive Spectrometry (WDS) analytical techniques on a single platform, Neptune provides the power and flexibility of EDS with the resolution, precision, and detection limits of WDS. Together the two techniques extend X-ray microanalysis capabilities and provide solutions to the most challenging analysis problems. Each technique can be used independently or the data can be integrated to provide results which were previously unachievable.
-
Product
Bolometer Systems
-
The detector comes with an IR light collecting cone assembly, vacuum-sealed wedged window, field of view baffling, and low noise electronics. The bolometer system is then outfitted with a single cut-on IR filter or a cold, manually operated, 2 or 3 position filter wheel. We offer a selection of far IR cut-on long pass filters that range from 10 to 285µm.
-
Product
AXI Inspection Systems
-
Dou Yee Enterprises (S) Pte Ltd
Dou Yee Enterprises AXI Inspection Systems
-
Product
Battery Cycle Test Systems
-
Chroma Systems Solutions, Inc.
High precision, integrated battery charge / discharge cycle test systems designed for lithium ion and other chemistries and applications including EV batteries and energy storage systems. Chroma’s battery test equipment provides advanced features including regenerative discharge systems that recycles energy from the battery back into the channels in the system or to the grid. Systems are configurable and flexible with multiple channel capabilities that can be upgraded as testing requirements change.
-
Product
Weather Detection Systems
-
General offers weather detection systems that use a base station to display inputs received wirelessly from remote sensors. The RGR150 can track rainfall amounts as well as temperature and/or relative humidity. WS821 & WS831DL Weather Detection Systems are full-featured wireless weather stations that add wind speed readings and track trends in barometric pressure that can serve as the basis of a short-term weather forecast. Barometric pressure is also available from a dedicated wireless station (the DBAR880), and the original weather forecasterthe ABAR300 Analog Barometer.
-
Product
Sol Manual Precision Measurement Systems
Sol
-
The Sol Vision System implements new technologies to provide speed and accuracy on a reliable and affordable measuring machine. The Sol bridges the gap between manual and automated measurement systems.
-
Product
USB PD Test System
6050
-
Single Output USB PD USB PD basic version：the single-group test systemarchitecture is as shown in the table, 5302A AC Source, 3302F + 3310F series and9922-R Quick Charge Controller.
-
Product
Sawmill Green Lumber Sorting System
-
The transverse sawmill meter sorts pieces into four moisture groups with similar drying characteristics by assigning a dry-ability index number. This critical first step in end-to-end moisture control improves kiln performance by reducing aggregate standard deviation and total drying time when compared to unsorted loads.
