-
Product
Chevrolet Oxygen Sensor
KS60113 - Chevrolet
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
Turbidity Sensors
-
Turbidity sensors measure the amount of light that is scattered by the suspended solids in water. As the amount of total suspended solids (TSS) in water increases, the water's turbidity level (and cloudiness or haziness) increases. Turbidity sensors are used in river and stream gaging, wastewater and effluent measurements, control instrumentation for settling ponds, sediment transport research, and laboratory measurements.
-
Product
Fluid Power Actuators
CQ
-
The CQ range provides an innovative fully-concentric and balanced actuator design for quarter-turn valves. The design features a helical mechanism that transforms linear piston motion into quarter-turn valve stem rotation. CQ actuators provide a much higher torque output for a given footprint than scotch yoke designs typically utilised to operate many quarter-turn valve types. It is therefore ideally suited for installation in confined spaces. Further, Rotork’s unique helical pin design provides higher efficiency than a helical gear mechanism utilised by other valve actuator manufacturers.As standard, the CQ torque output profile, like that of a scotch yoke actuator, is engineered to parallel the torque demand profile typically found with popular quarter-turn valve types. The CQ design however is unique in that the torque profile can be custom engineered and manufactured to meet specific, non-standard valve torque requirements.In our experience, the CQ standard range of sizes is suitable for applications that require a pneumatically powered actuator with torque demand less than 150,000 Nm. However, we also engineer CQ actuators with greater output and/or hydraulic power. Please apply to Rotork for these applications.
-
Product
Power Amplifiers
-
Your ultimate solution for sound distribution in the contractor/install market.
-
Product
MRI Power Supplies
-
MRI Power Supplies are used in MRI Imaging rooms in hospital environments. The lights in the MRI rooms require DC power. If AC power is used, the quality of the MRI imaging process is compromised. These units are ideal for the MRI room, where a 60 Hz flicker-free light environment is desired. CEHCO offers four models which are shown below.
-
Product
Microwave Drying Oven
SAM 255
-
The SAM-255 now with IntelliTemp Infrared temperature control provides rapid drying of all types of samples. The SAM-255 Workstation can analyze large-sized samples for moisture or solids.
-
Product
Powered VME430 Crates
-
The CERN VME430 standard, often called "Nuclear VME", is an extension of the VME64 Standard and was introduced in 1980 by the European High Energy Physics Laboratory CERN. It is fully backwards compatible to VME/VME64.
-
Product
Zirconia Oxygen Sensors
-
PST offer a range of zirconia oxygen sensors that use a unique closed loop measurement system.The sensing technology and stainless-steel construction allow Zirconia oxygen sensors to be used in environments where extreme pressure, temperature and high humidity are present.
-
Product
Handset Power Amplifiers
-
Broadcom Handset Power Amplifiers support different operating modes (CDMA, UMTS, LTE, and GSM/EDGE) and multiple frequency bands offering premium performance in a very small form factor.
-
Product
AC Power Sources
Ls-Lx Series
-
AMETEK Programmable Power, Inc.
The Ls/Lx Series is a completely improved new product based on the popular California Instruments L Series. Both the Ls and Lx feature many basic AC Source capabilities at a very reasonable price. For more information on either product, please click on the product tab on the right.
-
-
Product
Integrated Microwave Assemblies
IMAs
-
Communications & Power Industries
• High power handling• Low-noise figure• Calibrated couplers• Variable attenuation• Frequencies from 100 MHz to 40 GHz
-
Product
Solar Power Meter
Model K-SPM-11
-
Kusam Electrical Industries Limited
SOLAR METER A device used to measure solar power. When the sun shines brightly, just take the KM-SPM-11 and aim its opening at the sun, and you will see how powerful the sun is. If you want your skin white, you surely cannot do without it!
-
Product
Smart & Precise Color Sensors
-
The colorSENSOR CFO is a new controller for precise color recognition in industrial measurement tasks. The CFO series is distinguished by high color accuracy, state-of-the-art interfaces and intuitive operation. The controller is connected to CFS sensors with integrated optical fibers, which can be adapted for different measurement tasks. The colorSENSOR CFO is used in color recognition tasks on interior parts such as head supports, in packaging control or in color sorting tasks with crown caps, closures or labels.
-
Product
Nutrient | Oxygen | PH Sensors: PH Sensors
-
pH (potential Hydrogen) is a measurement of the level of acids and bases in water. Our pH sensors have been used extensively to research ocean acidification, coral reefs, coastal marine biology, and to conduct environmental monitoring.
-
Product
Industrial Power Tester
MicReD Power Tester 600A
-
The MicReD Industrial Power Tester 600A supports automatic testing and diagnosis of possible failure causes of power components. Built for manufacturing as well as laboratory environments, it can power the modules through tens of thousands, potentially millions, of cycles while simultaneously providing real-time failure-in-progress diagnosis.
-
Product
Sensors
2D Fiber Probe
-
Smallest and most accurate probe for 2D evaluations world-wideMechanical fiber sensor with optical evaluation from image processorTransmitted light and self illumination modeLowest contact force of 1 µNSphere diameters down to 25 µmControl and evaluation software for fully automatic measurements
-
Product
Web Sensor with PoE
P8652
-
P-line Web Sensor with PoE (Power over Ethernet feature) for measuring temperature, relative humidity and three binary inputs for two-states signals. Remote alarm.
-
Product
Power Conversion
-
The XRP6124 is a non synchronous step down (buck) controller for up to 5A point of loads. A wide 3V to 30V input voltage range allows for single supply operations from industry standard 3.3V, 5V, 12V and 24V power rails. With a proprietary Constant On-Time (COT) control scheme, the XRP6124 provides extremely fast line and load transient response while the operating frequency remains nearly constant. It requires no loop compensation hence simplifying circuit implementation and reducing overall component count. The XRP6124 also implements an emulated ESR circuitry allowing usage of ceramic output capacitors and insuring stable operations without the use of extra external components.
-
Product
Powered NIM Crate
NIMpact 300W With Fan Tray
-
NIMpact crates are low cost crates that meet EUR4100 and CE specifications. They are outfitted with a 300W power supply with over load and over temperature protection. 5U NIMpact crates are with fan tray.
-
Product
Sensors
-
Parker’s sensor and related offerings include pipeline gas temperature measurement solutions; electroactive polymer (EAP) technology sensors for measuring mechanical or thermally induced strain; RTD probes for reducing thermal coupling errors from thermowells; threaded, flanged, socket weld, weld-in, and Van Stone thermowells; vacuum pressure sensors; and wireless sensors, among other products.
-
Product
ATEX-Compliant IR Temperature Sensors
FLIR A310 ex
-
Explosive atmospheres need to be protected from ignition sources. Selecting equipment and protective systems which meet the requirements of the ATEX Product Regulations or similar regulations is essential. FLIR A310 ex is an ATEX compliant solution, with a thermal imaging camera mounted in an enclosure, making it possible to monitor critical and other valuable assets also in explosive atmospheres. Typical applications for the A310 ex include process monitoring, quality control, and fire detection in explosive locations. Because the FLIR A310 ex is rated IP 67, it can be installed in dusty environments. The Flame-Proof Enclosure "d"prevents any explosion transmission from the inside of the enclosure to the outside.
-
Product
Sensors
-
Diversified Technical Systems, Inc.
DTS offers a full line of high performance data acquisition systems, sensors, accessories and software to meet a wide range of critical test requirements. Let the DTS team of experienced engineers and test professionals help you find the right instrumentation for your application.
-
Product
Arbitrary Power Supply
-
Toellner Electronic Instrumente GmbH
Can generate relatively rapid variations of both voltage and current. It is designated an arbitrary DC power supply, if these variations take place within one quadrant (that is, both voltage and current remain positive at all times).
-
Product
Utility Power Source
SE-UDPS
-
Load boards for applications like mixed signal, analog and RF require active components. To drive these active components multiple utility power supplies are needed. The SE-UDPS from Salland Engineering is an economical way of adding more utility power supplies to your Advantest™ V93K to drive op-amps, buffers, relays and switches. The SE-UDPS extends the usefulness of your current fleet of V93Ks. You can also minimize the need to add external power supplies on your load boards.
-
Product
Drop Counter Logger Sensor
NUL-223
-
This sensor enables to count automatically drops and bubbles. It is perfect for titrations. Combined with the pH sensor it gives a very nice titration curve.
-
Product
DC/DC Power Supply
ISM-DC-AT512-P
-
The ISM-DC-AT512-P is a dual output, DC/DC power supply designed for small form factor embedded systems. It features a very wide voltage input range from 10 to 50 volts DC. This allows the unit to operate with 12, 24, or 48 volt battery or distributed DC power systems. It opens up a wide array of applications including transportation, Mil/COTS, security, solar-powered, and telecommunications.
-
Product
Power Monitor, AC-Powered, Field Adjustable
YMA/YQA
-
NAI's YMA and YQA Power Monitors are used to monitor voltage, frequency, and phase characteristics of single- or three-phase power lines. This allows normal operation of system loads when the power-line characteristics are within predetermined limits.High and low voltage and frequency limits, and "pick-up" and "drop-out" time delay are field-adjustable using potentiometers. These power monitors are ideally suited for rugged defense and industrial applications.
-
Product
Sensors for Contour Measurement
-
Leuze electronic GmbH + Co. KG
The CMS 700i 3D contour measurement system detects the length, width, height, deformations and position of any objects as they pass by, independent of their shape and surface. Even polybags are reliably detected. The complete system includes all components for operation and installation under one part number. In contrast, light section sensors record a height profile along a projected laser line. This allows objects to be detected with high resolution in multiple dimensions. The integrated functions range from presence control to edge measurement and 3D object measurement.
-
Product
Ultrasonic Sensors
-
Omega's ultrasonic sensors provide non-contact measurement for a virety of factory and process control applications including tank level, roll diameter, proximity, dimensioning, and web break and
