-
Product
Acquisition Of Strain Gauges, Isolated, 18-bit
APCI-3300-8
-
18-bit resolution, unipolar, 16-bit accuracy 8 differential inputs for strain gauges Voltage range 0 to + 2.5 V 8 independant voltage sources for the connected pressure sensors Output voltage for the voltage sources 5 V, 40 mA Gain and offset calibration Calculation of the pressure value through software Programmable gain 16-bit accuracy with sample rates of 20, 40, 80 or 160 Hz 4 digital input channels, 24 V and 3 digital output channels, Open Collector, isolated
-
Product
Motion Control
-
The CAES Motion Control portfolio includes high-reliability DC motors, actuators, controllers, gimbals, pedestals, rotary joints and RF rotating subsystems.
-
Product
PCI Data Acquisition Boards
AD14-100DMA Series - Dual 14-bit A/D, 25 MS/s
-
Model AD14-100DMA is similar to the ADDA14-100DMA, but does not have D/A converters.
-
Product
SPM Controller
-
the ability to provide independent torque (current) control or speed (voltage) control to the motor at any throttle position.
-
-
Product
PCI-8361, PCI Host, 100 MB/s, Copper Cable MXI-Express Device for PXI Remote Control
781394-01
-
The PCI‑8361 is an MXI‑Express remote controller for devices or systems over cabled PCI from a computer with a PCI slot. The PCI‑8361 card provides a PCI link over a copper cable to the PXI‑8360 remote control module when used for PXI system control. This link is transparent to software applications and drivers, so computers and servers can control connected devices with no additional programming. With NI remote controllers, PXI modules can be used as if they are PCI devices directly installed in the computer.
-
Product
Limit Controller
1401+
-
The 1401+ limit controller is a member of the P series family. The instrument provides a latched relay output which is activated when process value either exceeds or falls below the a pre-set limit level, providing a fail-safe cut off which has to then be reset before the process can continue.
-
Product
Measurement And Control
-
Amplicon supplies Measurement and Control products for every type of application, from high-end Test & Measurement to a simple digital panel meter installation. We have products that can monitor, display and log high and low speed signals.
-
Product
16-CH 12-Bit 110 kS/s Multi-Function DAQ Card
PCI-9112
-
- Supports a 3.3 V or 5 V PCI bus- 12-bit A/D and sampling rate up to 110kS/s- 16-CH single-ended or 8-CH differential inputs- On-board A/D FIFO
-
Product
Remote Data Acquisition
-
Sometimes your sensors or the piece of equipment you are trying to control is not in a convenient place to have a PC close by. The sensors may be widely distributed through out your plant and it just wouldn’t be cost effective to run all your wiring to where the PC is. In addition, low level signals are more accurately acquired when digitized close to the signal source. In all these cases our REMOTE ACCES line of products will help. The REMOTE ACCES pods are intelligent, sensor to computer interfaces. Each pod can be used as an autonomous data logger to acquire data for later download. Or as many as 31 pods may be connected on a single two wire multidrop RS-485 network allowing a cable distance of up to 4000 ft. You can also go wireless and extend your range by adding RS-485 wireless transceivers to your serial port. Each unit comes in a rugged NEMA 4 enclosure and can withstand harsh industrial and marine environments.
-
Product
Data Acquisition Equipment
-
Get the data you want, where, how and when you want it. Fluke gives you a broad choice in data acquisition for process monitoring and laboratory test systems. You can choose a stationary or portable data logger. Transfer data to internal memory, to a removable memory card, or to your PC. Choose a standalone or distributed networked units. And you can expand your system from 20 to 1,000+ channels, depending on the series.
-
Product
Intel Atom® IPC Controller
AMAX-7570 V2
-
Optimized BIOS & Embedded OS for 1ms real-time control (Windows and Linux)Achieve 32-axis motion control with 500 μs EtherCAT cycle time under LinuxOPC UA and Modbus TCP/RTU as IT connectivity enabled by CODESYSEtherCAT, PROFIT, Ethernet I/P, CANopen as OT connectivity enabled by CODESYSUnlimited I/O points, fieldbus networks, and visualization variables for CODESYS applicationsCODESYS Visualization (Target and Web), SoftMotion and CNC/Robotics support by different packageAdvantech Data Connect (ADC) Library provides flexible and highly efficient data connection with 3rd party application software through symbols (PLC Handler) & shared memory (C++/C#)Intel Atom® x6425RE (1.9GHz) processor with 8GB DDR4 memoryPort isolation for 8 x DI, 8 x DO, 2 x COM
-
Product
Control Unit
MX 62 TP
-
Teledyne Gas & Flame Detection
Bringing together the latest data logger and alarm unit for gas and flame detection systems, the MX 62 TP features an innovative HMI interface specifically designed to facilitate user-controller interactions.This interaction is simplified by a large, fully interactive 10" (up to 15") high-definition colour touchscreen, allowing for clearer visualisation of critical gas detection data.
-
Product
USB Data Acquisition (DAQ) Products
-
ACCES now offers USB-based data acquisition and control in both standard packaging and embedded OEM USB/104 board only options. These USB DAQ devices are perfect for a variety of applications requiring monitoring, control and industrial serial communications. USB is by far the most popular and compatible standard data interface for direct PC connection. Add the features you need in your application in hours, not days. Choose from over 100 different models and options (including extended temperature) encompassing analog I/O, digital I/O, counter/timer, and serial I/O configurations. Experience simple and immediate connection to any PC or embedded system with a USB port.
-
Product
Controllers & Software
-
Weiss Technik Controllers and Software offer advanced technology for Programming, Control and Monitoring for your testing.
-
Product
NI-7932, Xilinx Kintex-7 K325T FPGA, 2 SFP+ Port, Controller for FlexRIO
783765-01
-
The NI‑7932 features a programmable FPGA and embedded processor optimized for deployment in the field for reliable, extended operation for applications requiring advanced I/O capability with embedded signal processing. It includes a Xilinx Kintex‑7 K325T FPGA, 2 GB of onboard DDR3 DRAM, a dual‐core ARM Cortex‑A9 processor running NI Linux Real‑Time, and 2 SFP+ ports for data streaming. The registered trademark Linux® is used pursuant to a sublicense from LMI, the exclusive licensee of Linus Torvalds, owner of the mark on a worldwide basis.
-
Product
Network-Ready Data Acquisition System
DAPserver 500
-
The DAPserver 500 and DAPserver 502 – and the DAPserver 500R and 502R, the latter "R" models for rugged environments – serve as fully integrated test, measurement, and control products. Built with experience gained over many years of integrating third-party hardware, these high-performance combined systems are now available as standard products,
-
Product
Controls Systems for Engine Control and Combustion Analysis
NI Powertrain
-
NI Powertrain Controls systems incorporate the LabVIEW reconfigurable I/O (RIO) architecture to create some of the world’s most flexible and capable combustion analysis and engine control systems. The engine control systems can drive both solenoid and piezoelectric direct injectors, control timing events with 25 ns of precision, and implement novel engine control strategies such as next- and same-cycle control. The combustion analysis systems are available in both portable and higher performance stationary form factors.
-
Product
Data Acquisition and Analysis Software
Magnifi®
-
Eddyfi® Magnifi® is a constantly evolving, integrated electromagnetic inspection data acquisition and analysis software. It boasts an intuitive graphical user interface (GUI) suited to modern devices, powerful reporting functions and data management, as well as simple inspection configurations.
-
Product
PCI Data Acquisition Boards
AD12-100DMA Series - Dual 12-bit A/D, 25 MS/s
-
Model AD12-100DMA is similar to the ADDA12-100DMA, but does not have D/A converters.
-
Product
GPIB Controllers
-
All of ICS's GPIB Controllers and Drivers conform to IEEE-488.2 Standard and are HP-IB compatible.
-
Product
Ultra-Small, High-Shock Ethernet Data Acquisition System
SLICE6
-
Diversified Technical Systems, Inc.
SLICE6 is a modular data acquisition system featuring unmatched performance, flexibility and reliability in an ultra-small package. SLICE6 makes it easy to build systems in 6-channel increments and supports up to hundreds of channels per test.
-
Product
Motion Controllers
-
Curtiss-Wright Defense Solutions
Motion control systems for defense applications must be two things - accurate and reliable. As the brains of these systems, motion controllers are responsible for ensuring all other system components are just that, no matter the conditions.
-
Product
PXIe8862, 2.6 GHz 8-Core PXI Controller
790622-01
-
The PXIe8862 is an Intel Core i7 8Core embedded controller for PXI Express systems. You use the PXIe8862 for processor-intensive RF, modular instrumentation, and data acquisition applications. The PXIe8862 includes two 10/100/1000/2500BASET (Gigabit) Ethernet ports, two USB 3.0 ports, four USB 2.0 ports, as well as an integrated hard drive, serial port, two Thunderbolt 4 ports, and other peripheral I/O.
-
Product
Controller Software
EZ-View
-
EZ-View Software allows users to easily monitor and control their CSZ test chambers from any location. Features include advanced data logging, profile entry, graphs, system security with file encryption, alarm monitoring, and flexible trend. Control & monitor up to 128 devices from a single PC.
-
Product
Control Module
MOC
-
The MOC is our universal control module for a wide variety of tasks, such as controlling relays in the fixture.
-
Product
16-CH 16-Bit 250 kS/s Low-Cost Multi-Function DAQ PCI Express Cards
DAQe-2213/2214
-
ADLINK DAQe-2213/2214 can sample up to 16 AI channels with different gain settings and scan sequences. It makes them ideal for dealing with analog signals with various input ranges and sampling speeds. These devices also offer differential mode for 8 AI channels in order to achieve maximum noise elimination.
-
Product
Temperature Controllers
-
Panasonic Industrial Devices Sales Company of America
Panasonic's line of versatile Temperature Controllers are offered in a wide selection of inputs and outputs, including PID (built-in auto-tuning function included), analog signal conditioners with scaling, and panel meters with a very bright and easy to read display. The KT line of controllers (pictured) is well suited for a wide variety of machine and process control applications.
-
Product
SBC with E3940 CPU and Data Acquisition
SATURN
-
SATURN combines a feature-rich Atom-class processor-based SBC with a professional-quality industrial analog and digital data acquisition subsystem and flexible I/O expansion in a single board designed for rugged applications.
-
Product
Gas Control
-
Teledyne has decades of experience to offer a full line of thermal mass flow meters and mass flow controllers. Our products provide solutions for a wide range of applications which include high and low flow ranges, corrosive gases and very high-temperature environments. With the assistance of our experienced application engineers and global sales network, we will help you find a reliable, repeatable and durable solution for applications in both laboratory and industrial environments. Your needs can be met by using quality flow instruments designed and manufactured by Teledyne Hastings.
