-
Product
Antenna Pedestals
-
Kratos Defense & Security Solutions, Inc.
Kratos provides a range of high duty cycle, full-motion pedestals for such applications as fixed ground terminal surveillance and gear-driven pedestals for tracking antennas, communications systems, and weather radar. Manufactured to ISO9001 standards, they support different diameter antennas and radome requirements.
-
Product
Log Periodic Antenna
ZDS7-1-6G-832
-
Log Periodic Antenna, Frequency 1~6GHz, Gain 9dBi, VSWR 2.5, Linear polarization, N-Female
-
Product
Antenna, Loop
EM-6874 | 20 Hz – 30 MHz
-
The EM-6874 Loop antenna is nominally used 20 Hz to 30 MHz and is designed for uncalibrated substitution measurements of shielding effectiveness as described by MILSTD-285, IEEE STD 299, and NSA-65-6.
-
Product
Antennas
-
Below are a selection of compatible antennas available for the NAV6 Series of NAVTEX products as well additional accessories for mounting and a fitting to your boat. Please browse the tiles below to find out more.
-
Product
GPS Antenna Signal Splitter 4 Way, Type N Jack, 1000 - 2000 MHz, 50 Ohm
GPS400
-
INSTOCK Wireless Components, Inc
GPS L1 - L5, GLONASS, Galileo SplitterLow Insertion Loss (0.4 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.10 : 1 avg)15 VDC & 75 mA max on DC block portsRoHS Compliant Splitter Construction
-
Product
Antenna, Omni-Directional Wideband Discone
EM-6105-1 | 30 MHz – 3 GHz
-
Electro-Metrics EM-6105-1 is a broad-band vertical co-linear array. It provides very wide frequency range omni-directional coverage in a single package. The antenna collapses for convenient storage and transport.
-
Product
GPS Antenna Signal Splitter 3 Way, SMA Jack, Passive, L1 & L2, 50 Ohm
GPS310
-
INSTOCK Wireless Components, Inc
GPS L1 - L5, GLONASS, Galileo SplitterLow Insertion Loss (0.3 dB avg)High Port to Port Isolation (30 dB avg)Excellent VSWR (1.10 : 1 avg)15 VDC & 75 mA max on DC block portsRoHS Compliant Splitter Construction
-
Product
Helical Antennas
-
Is an antenna consisting of one or more conducting wires wound in the form of a helix.
-
Product
Antenna Calibration
-
TDK Test Services offers testing to domestic and international EMC test regulations, including IEC, ISO, CISPR, and SAE. Test services are offered in our 3m semi-anechoic chamber, 3m fully-anechoic chamber, 10-meter open area test site, and our shielded conducted test chamber.
-
Product
L-Band Panel Antenna with 11 dBi Gain
LS-08-PL
-
The Lumistar LS-08-PL L-Band Panel Antenna is the ideal companion to the LS-25 Series Receiver to provide a low cost receiving system with extremely high performance. This medium size, lightweight antenna is available in either Horizontal or Vertical polarization. It can be mounted to a pole, or purchased with the optional tripod.
-
Product
Antenna Coupler, 600 MHz - 8 GHz
dbCOUPLER MINI
-
Have an application where space may be an issue? The dbCOUPLER MINI provides comparable performance at 2/3 the size of the standard dbCOUPLER.
-
Product
EMF Measurements Antennas
-
An isotropic antenna that allows to carry out radiated emission and environment exposure measurement (elettrosmog) to the radio frequencies in proximity of radio and television stations and repeaters for mobile telephone.
-
Product
Dual Polarized Broadband Horn Antennas
-
Linear polarized dual double ridged broadband antenna for receive and transmit applications made of aluminium.
-
Product
Antenna
-
The multifunctional antennas are designed to meet the harsh environmental conditions and limited space availability found on submarines. This is achieved by utilizing a unique stack array enclosed within a protecting fibre glass dome.
-
Product
5G Active Antenna Innovator’s Kit
AWMF-0129
-
The AWMF-0129 is an active array for 5G wireless applications developed using planar antenna technology resulting in a very low profile, lightweight unit. The surface mount assembled antenna board is based on Anokiwave’s AWMF-0108 Silicon Quad Core IC and demonstrates the performance achievable using low power silicon integration and efficient antenna layout and design. Using the AWMF-0108, the antenna provides +50dBmi output power while consuming just 12W DC power in the RF circuits and has achieved Gb/s data rates in OTA trials. The electronic 2D beam steering is achieved using analog RF beam forming, with independent phase and gain control in both Tx and Rx operating modes. The AWMF-0129 antenna leads the way in showing how 5G coverage can be rolled out by network operators using the mmW bands, with low power footprint and high energy efficiency, while meeting key operating specifications for data rate, latency, coverage, and reliability.
-
Product
Double Taper Horn Antenna
MDTH series
-
This product is the antenna that corresponds to the radar pulse immunity test for automotive equipments. Automotive manufacturers have required the electric field strength of 600 v/m. Amplifier system and cable will be cheaper, and will contribute to the ecology.
-
Product
Antenna Kit
EM-6000 | 10 KHz – 18 GHz
-
Electro-Metrics antenna kit consists of OmniDirectional and Directional antennas covering the frequency range of 10 kHz to 18 GHz. Accessories are included for use with the antennas. All antennas and accessories are placed in two carrying cases, which are provided.
-
Product
Biconical Antennas
-
For many years most standards called for the use of a half-wave dipole antenna set for frequencies above 80 MHz. However, to reduce test time, broadband antennas such as the biconical antenna and log periodic antennas began to be accepted. Broadband antennas, compared to half wave dipoles, reduce test time because the technician did not have to stop the test to adjust the dipole antenna for each frequency. A.H. Systems'' 7 models of Biconical Antennas operate efficiently over the frequency range of 20 MHz to 18 GHz. Suitable for FCC, MIL-STD, VDE, TEMPEST, and immunity testing, each Biconical antenna will provide reliable, repeatable measurements.
-
Product
Antenna Impedance Converter
-
The low noise impedance matching equipment has a high impedance input with minimized capacity. With the 50 Ω output it can be used with common EMI receivers or spectrum analyzers to measure the emissions received by an antenna on a vehicle.
-
Product
Broadband Horn Antenna (4GHz - 40GHz (calibrated from 18GHz))
PowerLOG® 40400
-
• Extremely wide frequency range from 4GHz to 40GHz (calibrated from 18GHz to 40GHz) • Supports high input levels up to 300W (peak) or 150W (CW) • High gain up to 17dBi • Delivered including specific calibration data • Perfect for EMC and immunity tests with Spectrum Analyzer.
-
Product
2-In-1 Wi-Fi Tri-Band MIMO Antenna, Covering 2.4/5/6GHz Bands, Support Wi-Fi 6E/7
AIW-515
-
2-in-1 WiFi Tri-band MIMO antenna, covering 2.4GHz/5GHz/6GHz bandsSupport latest Wi-Fi6E/7PIFA antenna with omni-directional radiation patternMagnetic/Adhesive MountRP-SMA male connectorIP67 waterproof resistant for outdoor
-
Product
WiFi, Bluetooth, & BLE Antennas
-
Our wide selection of internal and external Wifi antennas and Bluetooth antennas enable connectivity for multiple devices in nearly any location.
-
Product
SATCOM Antenna Positioners
-
CAES is a leading designer and manufacturer of custom SATCOM Antenna Positioners for military airborne, ground, and naval applications.
-
Product
Measuring Small Antennas
-
If you have a small PCB with a small antenna you can't use a thick cable and a large connector. Not only is this impractical (how to connect the connector?) but the metal bulk will also affect the antenna and grounding properties of your PCB. The measurement will be useless. MegiQ promotes the use of the small and popular UFL connector and its associated cables. The UFL socket fits on almost any PCB and it can be improvised on a board without a UFL footprint.
-
Product
GPS/GNSS Antenna Signal Splitter 3-Way, TNC Female, IP67 Weatherproof, 1-2 GHz
GPS321
-
INSTOCK Wireless Components, Inc
GPS321 is a three way, passive, GPS signal splitter ideal for splitting a GPS antenna signal between two receivers while providing a DC current path to power a remotely located active GPS antenna from one receiver while blocking the DC path from the other. Furnished with TNC female connectors all ports. A special feature of this unit is the 200 ohm internal load which provides a current drain for the GPS receiver not powering the active antenna. Some GPS receivers incorrectly sense an antenna fault when there is no current draw. The 200 ohm internal load provides a simulated antenna current drain which prevents receiver faulting. Max voltage rating at the DC blocked ports is 15 VDC; maximum current rating is 75 mA. Max voltage rating at the DC pass port is 50 VDC; max current rating is 2000 mA.
-
Product
Low Frequency Active Antenna And Amplifier
Type NLF-2
-
A Hot, Active, Noise Reducing Antenna System that will sit on your desk and copy 2200, 1700, and 600 through 160 Meter Experimental and Amateur Radio Signals!
-
Product
Adjustable Dipole Antenna
SNA600a
-
The SNA600 antenna is a versatile tool for use with wireless microphone receivers or IFB transmitters. The center frequency of its 100 MHz bandwidth is tunable from 550 to 800 MHz. The frequency is set by adjusting the dipole elements using the scale printed on the body of the antenna. The elements fold for storage.
-
Product
Active Loop Antenna
KH30935
-
Beijing KeHuan Century EMC Technology Co,.LTD
KH30935 active loop antenna is used for adjusting, testing, measuring and other receivers. It has many advantages:1. The antenna coverage frequency is wide: 150KHz ~ 30MHz .2. The field strength value is measured according to the correction coefficient within the effective frequency range, which is convenient to use.3. The antenna has a small outer diameter and light weight, which is convenient for outdoor measurement.
-
Product
Horn Antenna
ZLB7-1-18G-10N
-
Horn Antenna, Frequency 1~18GHz, Gain 9dBi, VSWR 2.0, Linear Polarization, N-Female
-
Product
GPS/GNSS Antenna Signal Splitter 4-Way, TNC Female, IP67 Weatherproof, 1-2 GHz
GPS421
-
INSTOCK Wireless Components, Inc
GPS421 is a four way, passive, GPS signal splitter ideal for splitting a GPS antenna signal between two receivers while providing a DC current path to power a remotely located active GPS antenna from one receiver while blocking the DC path from the other. Furnished with TNC female connectors all ports. A special feature of this unit is the 200 ohm internal load which provides a current drain for the GPS receiver not powering the active antenna. Some GPS receivers incorrectly sense an antenna fault when there is no current draw. The 200 ohm internal load provides a simulated antenna current drain which prevents receiver faulting. Max voltage rating at the DC blocked ports is 15 VDC; maximum current rating is 75 mA. Max voltage rating at the DC pass port is 50 VDC; max current rating is 2000 mA.
