Partial Discharge Detection
indicate that localized dielectric breakdown within insulation has occured.
See Also: Partial Discharge, Partial Discharge Monitors, PD, PD Test, Partial Discharge Test, Partial Discharge Detectors
-
Product
Indoor Gunshot Detection & Localization
SHOTPOINT
-
Shotpoint’s indoor sensor includes the basic sensor board in a rugged plastic enclosure with an additional PoE module. The enclosure includes a mounting ring that attaches to a 1-gang electrical box or low voltage frame for easy mounting to walls and/or ceilings. Two(2) sensors with 165ft maximum spacing provide total area coverage and peace of mind in any indoor space.
-
Product
Battery Discharger & Capacity Tester
-
Fuzhou Fuguang Electronics Co., Ltd.
Battery Discharger & Capacity Tester
-
Product
Dike-Type And Partial Flume-Type Flowmeter
-
These flowmeters provide the means for flow measurement and flow control of open conduit channels in water supply facilities and sewage facilities.
-
Product
Battery Discharger & Capacity Tester
IDCE-8X0
-
Fuzhou Fuguang Electronics Co., Ltd.
Wide Range: IDCE-8X0CT series can cover 10V~480V for multiple batteries test requirements like telecom (48VDC), powerutilities (110VDC, 220VDC), UPSs (300-60 VDC), traction batteries(12-96VDC)etc.
-
Product
Contraband Detection EOD
-
Security Intelligence Technologies, Inc.
Contraband Detection for EOD and Law Enforcement users now have an edge with LED fiberscopes and the Dirty Bomb Detector. These can be used with our Bomb Jammers when dealing with the inspection for radio controlled weapons.
-
Product
PARTIAL DISCHARGE test set
pdnt02
-
International Biological Laboratories
This Test Kit is used for non-destructive means of assessing the quality of high voltage transformers, motors, cables etc., which are used in generation & distribution of electric power.
-
-
Product
Electrostatic Discharge Generator
STT-ESD-2005
-
Beijing KeHuan Century EMC Technology Co,.LTD
The STT-ESD-2005 ESD generator meets the requirements of IEC61000-4-2 and GB/T17626.2. Its maximum ESD voltage reaches 30kV, meeting the standard's ESD voltage requirements (Level 4 air-gap discharge requires 15kV). It is also suitable for a wider range of applications and future standards. Therefore, the ESD-2005 ESD generator can be used for ESD testing of most electrical and electronic equipment, ensuring test comparability and reproducibility.
-
Product
Battery discharge testers
-
The battery discharge testers are used to test batteries by discharging them in a specified mode: given resistive load, fixed discharge current, etc. Depending on the required power rating, various sizes are available from manually transportable testers to multiple electronically controlled units in a master/slave configuration. Five Series of standard models.
-
Product
Portable Metal Detection System
XT 8000
-
The new XT 8000 portable walk through metal detection system is a full featured digitally controlled unit that can be deployed in less than five minutes, yet stores away in a rugged carry bag for easy transport. Only $3,995.00 eachBuy NowOur Price $3,995.00 The new XT 8000 portable walk through metal detection system is a full featured digitally controlled unit that can be deployed in less than five minutes, yet stores away in a rugged carry bag for easy transport.XT 8000 is simple to set up and operate without specialized training. The system can be moved regularly to different facilities to provide security and deterrence while costing thousands less than permanently installing units at each site.
-
Product
Gas Detection System
TOC-625 MICRO
-
International Gas Detectors Ltd
For small systems up to 8 devices with simple I/O requirements this system is ideal. The TOC-625 Micro Gas Detection System Controller interfaces with existing TOC-30A addressable gas detectors and has auto detect and set up features making deployment fast and easy for installers not used to gas detection systems.
-
Product
Switched Limiting Amplifier With Detected Output
-
Limiting amplifier sets dynamic range from -10.0 to -5.0 dBm input to 2.0 dBm output. TTL controlled, fast switching and high isolation 10 dB On-to-Off, and includes internal filtering for improved harmonic performance. Analog detector monitored output, or dual RF outputs.
-
Product
DDR Detective Logic Analyzer
DDR4
-
NOW supports 3DS at 3200MT/s!Provides logic analyzer like deep transaction Listing and Waveform capture. Continuous Capture for Violations and Performance metrics NOT a fill memory and then post process like other tools. This is a FuturePlus ONLY feature!
-
Product
Bio-Threat Detection & Collection
IBAC 2
-
The IBAC 2 is a fully automated bio-detection sensor that can support continual, 24/7, air monitoring or can be set to targeting sampling windows to align to hours of operation. It alarms in less than 60 seconds when a bio-threat is present. IBAC can be configured to support automated aerosol sampling either in conjunction with its’ triggered alarms or at a set frequency sampling time. In wide service throughout the world, IBAC 2 is used to collect and detect aerosolized agents for all four classes of biological threats (spore, viral, cellular, and protein toxins) with low false alarm.
-
Product
Pinhole Detection
-
ElektroPhysik Dr. Steingroever GmbH & Co. KG
A pinhole detector checks coatings by means of electrical voltage. Microscopically small defects (>20µm) can then be detected in the coating of a surface. Even minimal defects in surface coatings can have fatal consequences so careful testing with the right pinhole detector is vital. Urgent action is required when just the smallest defect is found during pinhole detection of surface coatings. Minimal defects in the coating are sufficient to cause major damage. The PoroTest 7 pinhole detector from ElektroPhysik is an indispensable aid in the search for pores, cracks and other defects in non-conductive coatings on conductive base materials – go to the technical data.
-
Product
Motive Power Gas Detection
-
Protecting your employees and facilities from dangerous gas buildup—whether through hydrogen gas detectors, carbon monoxide detectors, or other specialized monitors—is essential for preserving lives and property. Implementing a gas detection system ensures a safe working environment while maintaining productivity and meeting regulatory requirements.
-
Product
FM/ATEX Approved Static Discharge Cable Reels
Cen-Stat Static Discharge Reels
-
Retracting cable reels are an alternative solution to using retractable Cen-StatTM spiral cable. They are normally specified for locations where there is a preference for ensuring process operators stow grounding clamps correctly for good "housekeeping" purposes when the clamps are not in use.
-
Product
Gas Detection System Controller
SMC Sentry IT
-
The SMC Sentry IT Controller is a powerful network-enabled hazardous gas detection system that operates up to 32 detectors and interfaces with devices over Modbus RTU, 4-20 mA, Sentry PSG Bus, and conventional dry contact. The embedded web application enables users to view important data remotely and provides connectivity into the Industrial Internet of Things (IIoT).
-
Product
Partial Discharge Measurement and Analysis System
UHF 800
-
Our UHF 800 is a system for measuring and analyzing partial discharges in the ultra-high frequency (UHF) range in testing environments with high levels of external noise.
-
Product
Electrostatic Discharges
ESD3000
-
ESD3000 is the only ESD generator in the market using standard AA batteries to offer full flexibility to the user to replace them when needed.
-
Product
Gesture, Color Sensors & Proximity Detection
-
The gesture product family performs advanced gesture detection, proximity detection, digital Ambient Light Sensing (ALS) and color sensing (red, green, blue and clear). It also implements optical pattern generation for barcode transmission and remote controls. The gesture sensor modules provide a highly integrated solution offering five essential functions to enable a touchless interface and to optimize the end user experience of communications and consumer electronics equipment. Gesture detection uses four directional photodiodes to sense IR energy emitted from the integrated LED, converting the measurements of reflected IR light into information about physical
-
-
Product
Partial Discharge Locator
INDIPOINT
-
Ultrasonic directional microphone for the location of PD The very best maintenance instrument for partial dischargetrapping in medium and high voltage plant.
-
Product
Capacitance Detection Probe
Which Ender
-
By sensing capacitance the Which Ender identifies if a wire is connected to a contact. When the Which Ender's button is pressed, a tone is produced. If a contact is connected to a wire, this tone will drop in pitch when the probe tip touches the contact. The Which Ender is essential for locating opens, breaks, and unused pins in connections.
-
Product
Advanced Handheld Partial Discharge Detector
PDetector
-
Power Monitoring and Diagnostic Technology Ltd.
The PDetector is an ideal device for On-Line Partial Discharge (OLPD) testing of MV and HV equipment which employs all 5 types of OLPD sensor technology: Ultra-High Frequency (UHF), Acoustic Emissions (AE), Ultrasonic, High Frequency Current Transformer (HFCT), and Transient Earth Voltage (TEV). The information from multiple sensors gives the PDetector the versatility to detect all types of PD in all types of substation apparatus. The exact type of PD activity can be determined effectively using multiple on-screen data spectrum analysis.
-
Product
Partial Discharge Pulse Calibrator
TPK
-
Partial discharge puls calibrator TPK is a battery-powered handheld device for determining the correction factor in a Partial Discharge test circuit and to verify the Partial Discharge measurement.
-
Product
Electrostatic Discharge Test
-
The electrostatic discharge test is designed to determine the ability of equipment to perform its intended function without permanent degradation of performance as a result of an air discharged electrostatic pulse. Electrostatic discharge is the result of an unbalanced electrical charge. Typically, it is created by insulator surfaces rubbing together or pulling apart. A transfer of electrostatic charge between bodies (materials, components, etc.) at different electrostatic potentials is caused by direct contact.
-
Product
Radiation Detection & Measurement Products
-
Detect, localize, identify, and measure radioactivity in any scenario. From routine monitoring and surveillance to emergency response situations, our advanced, integrated radiation detection instruments mitigate the threat and keep you safe. Our product portfolio of radiation detection solutions provides comprehensive, real-time monitoring, early warning, and complete information in the palm of your hand, in the work place, and in your neighborhood.
-
Product
Electric Safety Wall Detection Test Mode
-
AllWin Instrument Science and Technology Co., Ltd.
Electric safety wall detecting functionTest mode programmableACW to IR function toggle automatically
-
Product
IQ4 Vertical Fall Metal Detection
-
The IQ4 Vertical Fall is a gravity fed / throat metal detector system designed for inspecting bulk, powders and granules. This system is supplied complete with frame, throughput tube and a choice of sealed valve or cowbell reject, depending on application.
