Dust
See Also: Sand, Dust Chambers
-
Product
FTL Test Block
-
FTL testblock with dust cover and current disconnect pinThe FTL is a test block for interfacing substation devices (protection relays, fault recorders, revenue meters, ... ) to the voltage and current transformers and to other equipment on the system side of a power grid. The FTL test block uses disconnect pins to isolate the substation devices from the system side equipment. Once isolated, secondary injection can be performed using banana jacks on the front side of the test block.
-
Product
15.6" All-In-One Touch Computer
UTC-515K
-
15.6" All-in-One Touch Computer with Intel® Atom® N97/i3-N305 Processor. Low-power, fanless system design. Built-in Intel® Atom N97. 15.6" monitor with 16:9 widescreen display. IP65-rated front panel for water and dust resistance.
-
Product
Electrostatic Precipitator
-
HIGHVOLT Prüftechnik Dresden GmbH
Electrostatic precipitators are used for clean process and exhaust gases, for example, in the cement and building materials industry, in steel mills, in conventional power plants, and in waste incineration plants. The dust particles are discharged electrostatically charged by a spray electrode, deflected by a DC electric field and deposited on the electrode.
-
Product
IP66-Rated Waterproof Outdoor Gateway With C1D2, ATEX, IECEx Certification
UNO-430 EXP
-
Intel® Atom™ E3950 quad-core processor with 8GB of DDR3L memoryIP66 rating for protection from water and dust ingressWide operating temperature range (-40 ~ 70 °C/-40 ~ 158 °F)Built-in TPM 2.0 for hardware-based securityReserve M.2 3042/3052 B Key, M.2 2230 E Key for Wifi, LTE & GPS expansionEasy maintenance and installation with front door and cable gland designC1D2, ATEX, and IECEx certification for explosion toleranceMicrosoft Azure IoT Edge and Amazon AWS IoT Greengrass certified
-
Product
EN 50155 Ethernet Switch
-
Axiomtek's EN 50155 certified Ethernet switches (TEN series) are designed for rail and metro systems. The TEN series is designed with IP54 enclosure and M12 connectors for protection against dust and water and supports an extended operating temperature range from -40°C to 75°C.
-
Product
Cable Fault Locator
TX2001
-
Lowest Cost Full Specification Professional Graphical TDR Rugged Palm Top Design 350g (12oz) 5 Measurement Ranges up to 3000m (10,000ft) 50, 75 & 100 ohm Selectable Impedance Built in Tone Generator for Pair Tracing & Identification Suitable for testing all Communications Cables Water & Dust Proof to IP54 Complete with tool-belt holster & test leads
-
Product
Bearingless encoders
-
Baumer bearingless encoders offer contactless, magnetic and wear-free operation. Their reliable function is not affected by dust, dirt or moisture. They are extremely resistant to shocks and vibrations and have a virtually unlimited lifetime.
-
Product
Air Quality Measurement
-
Air pollution measurement is the process of collecting and measuring the components of air pollution, notably gases and particulates. The earliest devices used to measure pollution include rain gauges, Ringelmann charts for measuring smoke, and simple soot and dust collectors known as deposit gauges.
-
Product
Dynatrol® Level Switch for Extremely Lightweight Bulk Solids
CL-10GSS
-
Dynatrol® CL-10GSS Level Detector may be used for high-, intermediate-, or low-point level detection of bulk solids. It is constructed to handle extremely light weight applications that are difficult to measure like glass fibers, glass wool, paper dust, polyester powders and polymer powders. The CL-10GSS is typically used with bulk solids in the density range of more than 5 lbs/ft3.
-
Product
BNC (F) To Minigator Test Clips
2631
-
BNC (f) to minigator test clips. Converts BNC (male) cables / connectors to minigator test clips for test versatility. BNC connector is molded directly to the wire for pull strength durability and dust and moisture resistance.
-
Product
SDIO- Low Power Radios
-
Its industrial temperature support, robust enterprise security and 802.11ac capabilities make it an ideal solution for applications like factory automation with demanding environmental conditions such as with extreme temperatures, dirt, dust, moisture, shock, and vibrations. Its low power consumption also makes it suitable for portable handheld devices.
-
Product
Reservoir Isolators
-
Fluid contamination can lead to high maintenance costs and downtime in hydraulic systems. Parker reservoir isolators provide protection against the ingestion of airborne contaminants such as dust, chemicals and water vapor through the breather-vent of your hydraulic system. Utilizing an elastomer bladder as a lung, the changes in gas volume in a hydraulic system's reservoir can be trapped and prevented from mixing with the outside atmosphere. Unlike conventional breather-vent filters, Parker reservoir isolators provide a positive separation without the possibility of clogging or need for maintenance.
-
Product
Metallic Corrosion Detector
-
Xiamen IDEA Electronic Technology Co., Ltd.
Portable Metal Corrosion Detectors , is used for testing the steel pipe corrosion, stainless-steel tube corrosion and sheet materials corrosion, which can tell the high rate color LCD, can adjust phase, gain and testing frequency ,can used for testing the different metallic corrosion , such as corrosion pit, fluid dust scouring thickness reduction,crack, oxygen corrosion and hydrogen corrosion. has English and chinese operating interface, simple and visual operation.
-
Product
ZZ Power Booster 1200V/3000V
ZZ Booster-Transmitter
-
ZZ Resistivity Imaging Pty. Ltd.
*3,000W output power in 2 adjustable voltage ranges ( 400V/7.5A, 1,200V/2.5A), the FlashRES booster transmitter is particular useful for surveys in high resistive areas or IP surveys.*When the FlashRES booster transmitter is connected FlashRES-UNIVERSAL, for each current injection, the system could collect 61 voltage measurement, this greatly increases the data collection speed.*Uses two standard 12V batteries connect in series as input power source*The FlashRES booster transmitter is designed for heavy duty usage, the instrument is shock, water and dust proof.*Light-weight and easily mobilised
-
Product
Adjustable Range Reflective Photoelectric Sensor
EQ-500
-
Panasonic Industrial Devices Sales Company of America
The EQ-500 Series Adjustable Range Reflective Photoelectric Sensor is a multi-voltage compact Reflective Photoelectric Sensor that can function with 24 to 240 V.AC and 12 to 240 V.DC, to operate with any power supply around the world. Background and foreground suppression (DC Types) and a long sensing range of up to 2.5m is a key characteristic of the EQ-500 Sensor. With an IP67 rating, the EQ-500 can be used in harsh environments prone to water or dust making stable sensing possible.
-
Product
Miller 400A
44500
-
Rugged, lightweight case - safe to use on wet ground. Weatherproof, even with lid removed - IP67 rating for dust and water intrusion. Convenient case lid removal for ease of movement, with test leads attached, to new measurement locations. Resistance measurement range from 0.01Ω to 1.1MΩ . Resistance measurements are unaffected by any stray interference signals that may be present in the earth during readings, due to the use of narrow band-pass filters centered at 97Hz (the unit’s operating frequency). Runs on a set of C-cell alkaline batteries...no need to periodically recharge the unit or to plug it into a power source
-
Product
USD Sand & Dust Chambers
USD-Series
-
USD-Series Sand & Dust chambers provide an environment to test the exposure of automotive and electronic components to concentrated levels of dust in order to validate product seal integrity.
-
Product
Aerosol Monitor
DUSTTRAK II-8530
-
The DUSTTRAK™ II Aerosol Monitor 8530 is a desktop battery-operated, data-logging, light-scattering laser photometer that gives you real-time aerosol mass readings. It uses a sheath air system that isolates the aerosol in the optics chamber to keep the optics clean for improved reliability and low maintenance.
-
Product
Digital Small Strain Gauge
ZET 7110-DS
-
ZET 7110-DS digital small strain gauge (with integrated strain gauge) is also used for stress-strain state control of concrete structures, it is used within the scope of engineering structures monitoring systems (both stationary and mobile). Digital small strain gauge is used for stress-strain state control and alarm notification in the case of elastic range of stress value exceeding. ZET 7110-DS digital small strain gauge is supplied in air-tight shock-proof package with dust and moisture protection.
-
Product
Settling Dust Chamber
-
Dust material is placed in a collector, or trough, at the bottom of the chamber, where air nozzles periodically agitate the material, causing a cloud in the chamber. After the agitation, the dust cloud is allowed to settle onto the test sample, which sits above the collector.
-
Product
Ultrasonic Sensors
-
Ultrasonic sensors present the ideal solution for non-contact position and distance measurement in all industrial areas where environmental conditions such as dust, smoke or steam may affect the sensors. Objects consisting of a variety of materials can be detected to within millimeters regardless of color or shape.
-
Product
Swivel Sprays
1188
-
The Parker Conflow Code 1188 - swivel spray is an easily controllable, multi-directional spray unit used for dust suppression or cleaning of chutes in mining or quarrying applications
-
Product
Sequence Control Valve
Code 200
-
Parker Conflow’s Code 200 is a sequence control valve which switches on electrical equipment by detecting the movement of a conveyor belt in dust suppression applications.
-
Product
Air Quality / Gas / Flow Sensors
-
Panasonic Industrial Devices Sales Company of America
Panasonic offers compact, high sensitivity Air Quality, Gas and Flow Sensors for use in equipment or automation processes. Designed for air quality / IAQ monitors and home appliances, the Laser Type PM (Particulate Matter) Sensor can detect dust particles down to the 0.3 m size.
-
Product
ATEX Certified
-
Equipment tested and approved to operate safely in potentially explosive atmospheres containing flammable gases, vapors, or dust.
-
Product
Wireless Fiber Inspection Probe
OCI-20BN-W
-
OCI-20BN-W is a portable optical fiber connector inspector for checking fiber and connector end-face cleanliness, ideal for bench top and fiber optic network installation technicians to eliminate error caused by poor quality or improper cleaning.OCI-20BN-W offers excellent viewing on connector/fiber end-face and is able to feature to record and save image/video of fiber end-face; It can be connected to PC or phone by WIFI.More than 40 assorted high-precision tips designed for inspection solutionsAngled/Lengthened tips for awkward positions.Connect smart phone for testing FiberEye2 is the application on an android or IOS smart phone to capture, display and record the fiber end-face image from the Wi-Fi probe.Connect tablet/laptop for testing EFD is the analysis software on Windows tablet/laptop to have dusts, and scratches on end face inspected, analyzed, compiled and reported
-
Product
Industrial GigE Camera 29x29 mm
LUCID Triton
-
Industrial GigE cameras;Protection class IP67;Dust and water resistant;Vibration and shock resistance;Wide operating temperature range (from -20 to +50);Sony II, II and IV generations sensors from 0.4 to 24.5 megapixels;Linear camera Triton Line Scan 2k 60 kHz Model;Polarization models Triton 5.0 MP Polarization Model ;HDR model Triton 5.4 MP Model ;C-mount;Connectors: M8 / M12;Dimensions: 29x29 mm;Weight: 67g;Price: from 365 $.
-
Product
Synthetic Aperture Radar Image Processing
-
L3Harris Geospatial Solutions, Inc
Accurately and reliably monitoring the Earth is critical to many geophysical and geospatial applications. However, most sensors cannot capture data at night or through clouds, dust or smoke.
-
Product
Speed Sensors
Series 18
-
Features• Square-wave pulse frequency output• NPN or PNP output options• Single channel or bi-directional options• 5-24 VDC powered• Hall Effect or Magnetoresistive sensing options• Standard and wide temperature options• Rugged M18x1 stainless steel sensor housing (all models)• Four housing options• All sensors are epoxy filled and sealed against liquids and dusts• Works with Electro-Sensors magnetic pulser discs/wraps
-
Product
Spray Control Valve
Code 100
-
The Parker Conflow Code 100 spray control valve is a mechanically operated spray control valve used for dust suppression in mining where a conveyor belt is used.
