Profilers
See Also: Surface Profilers
-
product
Protective Inspection Kit for Hazardous Areas
The kit provides all the tools required for the on-site inspection of a coating, including surface profile, dewpoint, relative humidity, both wet and dry film thickness and also adhesive testing.Measurement parameters include:Surface inspectionSurface profileSurface contaminationClimatic conditionsCoating thicknessAdhesion
-
product
3U OpenVpx 6 Slot Profile BKP-CEN06-15.2.12-3
1OVX306JX3-1X11R
VPX central switch, payload in Slot 1 connected to slot 2, channel Gbaud rate up to 6.25, 3U, 6 Slots.
-
product
Syscal Junior
The Syscal Junior is an all-purpose resistivity and induced polarization sounding and profiling system for environmental applications. The system is supplied as a standard sounding system capable of recording two measurements simultaneously, perfect for performing offset Wenner sounding arrays. The output current is automatically adjusted (automatic ranging) to optimize the input voltage values and to ensure the best measurement quality.
-
product
2U Rackmount Chassis For ATX/ MicroATX Motherboard With Low-Profile Rear Bracket
RK-270MB-LH
- EIA RS-310C 19” Rackmount Standard - One 5.25'' drive bay and three 3.5'' drive bays- Supports 300W, 500W Flex ATX power supply- Support 7 low profile slots- Replaceable and easy-to-clean air filter- Front mounted fan module for easy maintenance
-
product
VPX/open VPX 5 Slot 6U
VPX technology enables nearly unlimited flexibility when it comes to interconnections between the slots.OpenVPX (ANSI/VITA 65 Standard) addresses this by specifying a set of standard profiles of interconnections. Comtel Backplanes are equipped with Air-/-Plane technology. It extends the life of the existing VPX connector system (MultiGig RT2) and enables unprecedented signal integrity performance which complies with IEEE 802.3bj 100Gb/s standard (4 Ethernet channels via fat pipe).
-
product
CompactPCI 3U 8 slot 64 bit right justified, P1s P2l
102CPCI308-20X0
CompactPCI 3U 8 slot 64 bit low profile with system slot right, fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
product
RF Shielded Test Enclosure, Low Profile
JRE 1618
Like its other brothers in the JRE test line, it features rugged welded aluminum construction with superb RF shielding effectiveness. Long life door gasket material along with double edge engagement not only provides solid RF shielding, but smooth trouble-free operation over its lifespan.
-
product
VPX/open VPX C-Frame 5 Slot 6U
Our 2nd Generation C-Frame offers the next level of flexibility in VPX development platforms. Not only can the customer exchange the type of card guides (convection, conduction, AFT) in a blink of an eye but now also the signal backplane. Thanks to Bi=/=Plane®technology, power and signal parts of a VPX backplane are separate PCB assemblies. This enables uncompromised signal quality along with faster turn around for the design of custom profiles.
-
product
Atomic Force Microscope
3DM Serirs
Park Systems has introduced the revolutionary Park 3DM Series, the completely automated AFM system designed for overhang profiles, high-resolution sidewall imaging, and critical angle measurements. With the patented decoupled XY and Z scanning system with tilted Z-scanner, it overcomes the challenges of the normal and flare tip methods in accurate sidewall analysis. In utilizing our True Non-Contact Mode™, the Park 3DM Series enables non-destructive measurement of soft photoresist surfaces with high aspect ratio tips.
-
product
Electronic Test & Measurement Equipment
We are known worldwide for the M.O.L.E. Temperature Profiler. The Mole is used in the Electronic, Paint, Food, and the Industrial marketplace. The Mole is a stand alone, 6 channel, temperature profiler that it is used in many harsh processes that require the temperature measuring instrument to be inside the heating chamber or "ride along" with the parts or process being measured over time such as Solder Reflow Ovens and Wave SolderMachines.
-
product
Multistandard Test Pattern Generator
TRF-950
TRF-950 is universal multistandard equipment suitable for analog TV systems and digital video. This generator supports all analog standards (PAL, SECAM, NTSC) and substandards. Digital output offer DV601/656 signal. Generator is installed in low profile case suitable for desktop use as well as for use in Rack 19" stand.
-
product
Bar Code Verifier
TP140B Report Printer
The TP140B Report printer allows for printing of inspection reports from your Inspector series bar code verifier. The printer provides a simple report that will have a line for each bar code inspected. Note: The Verifier Computer Interface Report (VCIR) is required if you need the Scan Reflectance Profile (SRP).
-
product
Pressure Mapping
WIPER
Evaluate wiper blade force profiles and interface pressure distribution.
-
product
Connectors
Panasonic Automotive & Industrial Systems Europe GmbH
: They have to be as compact as possible and provide maximum reliability. To fulfil these requirements, Panasonic engineers have developed narrow-pitch connectors that utilize TOUGH CONTACT technology.In addition to their excellent shock and vibration resistance, these connectors feature an ultra slim profile, which makes them ideally suited for applications where space is valuable. Our versatile in-device connector product range offers the appropriate solution for practically any scenario.
-
product
Profile Projector
Baty SM300
300mm screen vertical light path projector with multi-function readout unit and printer. Robust design with full geometric measuring functionality ideal for the shop floor. Features • Top quality profile projector highly versatile and easy to operate • Large travel range 150mm x 50mm (6”x 2”) as standard • Linear scale stage with 0.001mm resolution.
-
product
HD Oscilloscope, 2GHz, 10 GS/s ESR, 4 CH, 500 Mpts/Ch (Single Channel), 12-Bit HD
T3DSO4204L-HD
2GHz, 10 GS/s ESR, 4 CH, 500 Mpts/Ch (Single Channel), 12-Bit HD Low Profile Oscilloscope.
-
product
Low Profile Universal Tension or Compression Load Cell
LPU SERIES
Our LPU Series are low profile, universal tension or compression "pancake" type load cells. They are available in 14 ranges from 100 lb through 50,000 lb Hold down bolt holes are provided through the outer diameter and a threaded hole provided through the center for pushing or pulling from either end. The ALB load buttons located in our accessories section, are ideal for compression applications. The LPU Series are made from 17-4ph heat treated stainless steel. The sensing element incorporates bonded foil strain gages of the highest quality and are sealed for protection against most industrial environments.
-
product
Riverboat SP
Teledyne Marine RD Instruments
The Riverboat SP is the top choice for deployment of the Teledyne RDI StreamPro acoustic Doppler current profiler. Upgrade from the standard StreamPro float to the more stable, rugged and fully corrosion-resistant tethered boat. The Riverboat SP makes safe, easy measurements of discharge in relatively slow and fast flowing waters. Made of unbreakable polyethylene, the Riverboat SP is strong and can handle tough deployment conditions. The standard boat configuration fits a TRDI StreamPro ADCP, and the latest instrument clamp is suitable for the StreamPro with or without an internal compass upgrade.
-
product
Multibeam Echosounder - Deep Water
HydroSweep DS
The HydroSweep DS is a deep water multiebeam echosounder ideally suited for seabed mapping in deep water up to full ocean depth based on a sonar frequency between 14 kHz to 16 kHz. Beside bathymetric depth information from 10 m to more than 11,000 m, sidescan data and backscatter data for seabed classification are acquired. The HydroSweep DS does not only gather sea floor information, but also uses adaptive bottom tracking windows to identify sonar targets in the water column and can be optionally operated as a parametric sub-bottom profiler without additional transducers and electronics.
-
product
Surface Roughness Tester Profilometer
TIME®3231
Beijing TIME High Technology Ltd.
TIME® 323X series is advanced high-end surface roughness measuring instruments with wide testing range (±400µm) and high accuracy (tolerance±5%, repeatability 3%). Meanwhile, TIME® 323X surface roughness tester features with skidless/skid measurement, which means it can reach smaller and harder to reach parts than other conventional tools. Up to 55 paramenters for roughness, waviness and primary profile are supported. Apart from those features mentioned above, TIME®3231 is loaded with 90° measurement function.
-
product
6U Switch Board
VP68801
LinkedHope Intelligent Technologies Co.,Ltd.
VP68801 is a China local design VPX Switch, compliant with VITA46.0, VITA48, and VITA65 specifications. The Profile of VP68801 is SLT6-SWH-16U20F-10.4.2, which uses Gb Ethernet as control plane and SRIO as data plane. It is mainly applicable to high-speed data exchange and routing among different types of payload boards in a VPX chassis. The switching board is designed as 6U VPX form factor, supporting both traditional air-cooled version and conduction-cooled version. With reliable anti-shock and vibration capability, excellent heat dissipation performance and unique environment protection design, the whole board can be stably operated in the wide temperature environment of -40°C to +85°C.
-
product
Syscal Kid Switch
Specifically designed for very shallow, high resolution resistivity sounding and profiling, the Kid is the most compact of the Syscal range whilst retaining the well-known reliability and measurement accuracy of its counter parts.
-
product
756W to 1512W - Single Output
PF-A Series
*Low Profile (0.5")*0.95 Power Factor*EN61000-3-2 Compliant*Parallel Operation
-
product
Multi-Channel 1553 Interface for Single Lane PCI Express Systems
PCIE1L-1553
Alta Data Technologies’ PCIE1L-1553 interface module is a multi-channel (1-2), ½ size, Low Profile, One Lane PCI Express 1553 card with the latest software technologies. The PCI Express card is based on the industry’s most advanced 32-bit 1553 FPGA protocol engine, AltaCore™, and by a feature-rich application programming interface, AltaAPI™, which is a multi-layer ANSI C and Windows .NET (MSVS 2005/08/10 C++, C#, VB .NET) architecture. This package provides increased system performance and reduces integration time.
-
product
E1 Ethernet cable, twisted pair 1m
182219-01
8-Pin Male Ethernet to 8-Pin Male Ethernet, CAT-5E Ethernet Cable - The 8M-8M Ethernet Cable connects devices to network hubs or switches. The cable has straight-through wiring and is available in different lengths and thin profile options.
-
-
product
6U OpenVPX 5 Slot Profile BKP6-CEN05-11.2.5-1
1OVX605FX1-1X01R
VPX centralized switch, channel Gbaud rate up to 3.125.
-
product
VME64x 4U 84HP 8 Slots
Hartmann Electronic’s 8 slot 19” rack mountable VME solution – The VME64x 4U system. This VME chassis comes with two 250W cPCI hot-swap power supplies with room for up to 4 supplies and horizontally oriented card slots. This platform conforms to VITA 1.1-1997 while providing a low profile, practical packaging solution for high-performance processors.
-
product
Stylus Profilometry
Dektak®
Bruker's Dektak stylus profilers are the product of over four decades of proprietary technology advances. They provide repeatable, accurate measurements on varied surfaces, from traditional 2D roughness surface characterization and step height measurements to advanced 3D mapping and film stress analyses. Dektak surface profilers have been widely accepted as a superior solution for measuring thin film thickness, stress, and surface roughness and form in applications ranging from educational research verification to semiconductor process control.
-
product
Virtual Interface Technology for 3D-IC Metrology
VIT
TSV profile (depth, top & bottom CD, tilt, SWA)-Residue Detection-RST-Copper Nail Height-Bump Height and Cu pillar height-Edge trim profile
