Optical Transceivers
convert, transmit and recieve electrical and optical signals.
See Also: Transceivers, Vector Signal Transceivers, Optical Receivers
-
Product
TRansceiver Module
CFP2
-
Eoptolink Technology Inc., Ltd.
Eoptolink CFP2-100GBASE-LR4 / CFP2-100GBASE-ER4 module supports a link length of 10, 20, 25 and 40km kilometers on standard single-mode fiber (SMF, G.652). 100 Gigabit Ethernet signal is carried over four wavelengths. Multiplexing and demultiplexing of the four wavelengths are managed within the device.
-
Product
IO-Link Transceivers
-
IO-Link is a Factory Automation fieldbus-independent communication standard dedicated to connecting sensors and actuators as described in the IEC 61131-9 standard. Easily integrated with any of the most commonly used communication protocols found in factory automation systems through dedicated interfaces or bridges, it is a simple solution for extending existing networks to connect remote sensors and actuators. Developers will take full advantage of the Industry 4.0 or Industrial Internet of Things (IIoT) concept where every sensor and associated data point is used to control and optimize even the most complex industrial processes in real time.
-
-
Product
Optical Detector
LG-9200
-
The LG-9200 is a non-contact type optical detector which emits red visible light and detects the reflected light from the rotating shaft. The reflection mark is used for the detection by affixing it on the rotating shaft. It enables detection at an angle. (reflective mark: HT-011 by Ono Sokki)The LG-9200 has a built-in compact amplifier and outputs the square wave (voltage) after waveform shaping.With a compact and light weight body, performances are upgraded compared to the previous model LG-916.(LG-9200 detection distance: up to 40 mm, response speed: up to 40 m/s)
-
Product
2-channel RF Transceiver Module
FMC30RF
-
Sundance Multiprocessor Technology Ltd.
The FMC30RF is an FMC Daughter Card which is fully compliant with the VITA 57.1-2010 standard. The FMC30RF offers in a small footprint a low power and fully featured Rx / Tx signal path for the development and deployment of advanced RF solutions. With a frequency range coverage from 400MHz to 3.0GHz* and up to 60MHz* bandwidth the FMC30RF provides flexibility and reconfigurability to a host of applications.
-
Product
Mini Fiber Optic, Patchcord, Receiver, 36", Polymer Optic Fiber, to SMA-plug
7-414845510-036
-
Mini Fiber Optic, Patchcord, Receiver, 36", Polymer Optic Fiber, to SMA-plug.
-
Product
Optical Slits
-
The APPLIED IMAGE Optical Slit reticles are available in sizes from 10μm (0.01mm) to 1,000μm (1.0mm) widths, on either Chrome on Glass or Chrome on Opal material, with an overall size of 25.4mm (1.0 inch) diameter.
-
Product
Optical Analyzers
DNIRA™
-
Neolitics’ DNIRA™ is a real-time, in-line process NIRS that delivers the performance and accuracy of a precision laboratory instrument in a compact, robust, in-line design. It’s easy to install and requires virtually no maintenance post-installation, eliminating the time and difficulty required to keep systems calibrated and the difficulty in replicating or scaling applications within a manufacturing environment.
-
Product
Optical Comparator
Golden Units
-
The use of the Golden Units is the easiest way to ensure that your production devices are inspected to the accuracy you expect. The use of an optical comparator brings into play the subjectivity of the operator and errors induced by bending leads on real parts during handling by the operator.
-
Product
Transceivers
-
Schweitzer Engineering Laboratories, Inc.
Transceivers convert between copper and fiber optics or between other communications interface standards.
-
Product
Optical Sensors
-
Many measurements are much easier to make with light. Southern Photonics designs and manufactures optical sensor systems for a wide range of applications including gas sensing and strain sensing.
-
Product
Fiber Optics
GEN II FOB
-
Fiber Optic converters Electrically isolate signals from the vehicle bus using common bridge and satellite modules interconnected with fiber optic cable for EMI and EMC testing.
-
Product
Optical Benches
-
There are two types of SPHEREA optical test bench, Autonomous, to meet very specific needs, Combined with a versatile bench, to enable multiple-system testing.
-
Product
Optics
-
Welcome to Thorlabs; below you will find links to optical components and systems, a subset of our entire line of photonics products. All single element optical components can be found under the optical elements link with the exception of optical components that have polarization properties since they have a separate link. Multi-element systems like beam expanders and objective lenses as well as interferometers, fiber collimators, reference cells, modulators, and other optical devices can be found by choosing the optical systems link. Thorlabs also manufactures an extensive line of free-space and fiber optic isolators; stock items ship the same day that they are ordered while our custom orders benefit from our streamlined design and manufacturing process, which minimizes lead time.
-
Product
Fiber Optic Sensors And Fiber Optics
-
Over 350 customized fiber optic solutions. Smaller, more precise, faster. Robust - High-temperature, chemically resistant, mechanically robust glass or plastic fibers. Better performance - Position-independent detection of irregular objects or liquids. Plug & Play - Intuitive parametrization with the Baumer Sensor Suite via IO-Link.
-
Product
TRC-8543, CAN HS/FD or LS/FT Transceiver Cable
783701-02
-
CAN HS/FD or LS/FT Transceiver Cable—The TRC-8543 is designed to provide flexibility in connecting a CAN bus to the NI-9860, PXIe-8510, and/or the native NI-XNET port on a cDAQ-9134 or cDAQ-9135 controller. You can connect the TRC-8543 to the port to support a CAN HS/FD or LS/FT interface. The TRC-8543 is an isolated cable that includes the necessary transceiver for the bus type. It also features termination resistors that you can enable or disable in software.
-
-
Product
Proteus Arbitrary Waveform Transceivers
PXIe Modules
-
The PXIe module of the Proteus Arbitrary Waveform Transceiver (AWT) is based on the PXI Express industry standard. This platform enables up to 4 direct to RF generator output channels and 2 direct to RF digitizer input channels and occupies only 3 PXIe slots - Allowing scaling to 100's of channels.
-
Product
Optical Connectors
-
Radiall's full range of optical interconnect solutions includes standard interfaces, optical termini, optical connectors and custom optical assemblies and subsystems. Suitable for harsh environments and designed for demanding applications where reliability and high performance are required, our cost-effective optical connectors are adapted to the specific requirements for the telecom, industrial, aerospace and defense markets.
-
Product
Digital Wideband Transceiver Analysis
S94610B
-
Digital Wideband Transceiver Analysis is an add-on software to Device Measurement eXpert (DMX) that adds cross-domain stimulus response measurements for digital/RF mixed-signal device characterization. Included Waveform Creator helps define digital IQ test stimulus waveforms that are used in the RF signal generators for receiver tests or downloaded to the digital-to-analog converters for transmitter tests. The DUT control is customizable to accommodate various data converters and transceiver types by defining device operation settings, transmit/receive switching, reading and writing digital IQ waveform from and to DUTs. Acquired RF or digital data is processed in the VNA’s applications for faster, accurate measurements and analysis.
-
Product
Optical power meter with Optical laser Source
-
Shanghai Baudcom Communication Device Co.,Ltd.
The Multimeter combines a power meter with a 2-wavelength laser source,for optical fiber network installation and maintenance. With the large capacity of data storage,it's very convenient for field testing and transfering the test results to PC through USB interface.
-
Product
Test Board For SFP+ / SFP28 Transceiver
ESFP280
-
The OPTELLENT ESFP280 is a cost-effective and convenient test board for testing SFP/SFP+/SFP28 optical transceivers in R&D and manufacturing environments. The ESFP280 is equipped with high quality RF connectors for data signals and test points for low frequency control and status signals. The ESFP280 is equipped with power supplies to enable voltage margining. Key status signals are displayed using LED indicators.
-
Product
Optical Inspection
-
Typically, in a standard PCB manufacturing facility, there will be a department where people perform inspection of PCBs through a manual processes, such as visual inspection with magnifiers, microscopes, etc...
-
Product
Optical Modulator
-
Is an Intensity Modulator that is manufactured with Annealed Proton Exchange(APE) process, it features a zero-chirp design and Polarization Maintaining(PM) fiber output. Features 20 GHz E/O bandwidth, a highly linear transfer function and excellent extinction ratio. Applications include digital transmission up to 20 Gb/s, analog RFoF transmission to 20 GHz, optical pulse generation, mode-locked fiber laser and microwave optical link.
-
Product
Single Fiber Transceivers
-
Single strand fiber solutions are the simplest way to fiber optimization,immediately doubling the capacity of the installed fiber plant. Insteadof using two dedicated strands, one for receiving and the other fortransmitting, each strand carries a bi-directional signal. The fiberplant capacity doubles, which in turn can double the per fiber returnon investment (ROI) with no need for more physical fiber. Thesesolutions have been incorporated for many years in the Fiber Driver,MRV's Optical Multi-Service product line. Recent technologicaladvancements at MRV have yielded many new variations of thesesolutions, doubling the efficiency of fiber even down to Ethernet inthe First Mile.
-
-
Product
Optical Fiber Ranger
OFR300
-
Shanghai Tarluz Telecom Tech Co., LTD
OFR300 Optical Fiber Ranger is the most portable test instrument in the industry. It adopts the OTDR technical principles and integrates the powerful analysis software, which enables the OFR300 fiber ranger detect fiber faults location more accurate and easy.
-
Product
Transceivers
-
Macom Technology Solutions Holdings Inc.
At MACOM we offer monolithic and stereo Doppler transceivers for directional motion detection. Our transceivers are used in a variety of applications such as automatic door openers, ground speed recorders and police radars. MACOM’s transceivers are well suited for high volume applications where small size and reliability are required.
-
Product
Reticles, Optical Slits, Optical Apertures
-
With over 30 years of experience in the manufacturing of high precision Reticles, Slits, Apertures, and Pinholes, APPLIED IMAGE has gained a reputation for delivering precise and accurate parts. We have supplied thousands of these parts to be used in Day/Night Sights, Binoculars, Targeting Systems, Telescopes, Tank Sights, Microscopes, and many other Bore-Sight devices.
-
Product
Optical Laser Source
SAT-3E
-
Shaanxi Aitelong Technology Co., Ltd
SAT-3E optical laser source fits to optical power meter to measure fiber loss and evaluate transmission performance. They are indispensable tool for optical network installation, trouble shooting, maintenance and widely used in LAN, WAN, CATV, remote optical network, etc.
