Clamp Meters
combine meter and current probe into integrated instrument.
-
Product
Moisture Meters
-
Traceable® Moisture Meter displays material, wood, wood product, and paper moisture content 9.0 to 30.0% with a resolution of 0.1% and an accuracy of ±(4% of the reading plus 5 digits). Memory contains nine material groups such as fiberboard, construction material, and calibrations for 150 types of wood. For all other products, user establishes reference moisture readings. Once programmed, the meter reports directly in percent moisture. Simply touch a material to measure moisture. Takes only seconds. Jumbo-size digits are 1-3/8 inches high.
-
Product
Enclosure, 10 Module With 3 Cable Clamps
410112252
-
This aluminum enclosure is for ITA Part # 410 104 123 and allows your 10 Module Solution to be customized to your needs. The cable clamps are 1" ID. ITA strain relief plates are not needed.
-
Product
AC/DC Clamp Milliammeter (CE)
M-700
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*High sensitive for low range leakage current.*Suitable for measurement of 4-20mA DC controlled circuit.*DC mV analog signal output.*Lowest influence from Magnetization and Terrestrial magnetism.*Wide measuring ranges up to DC 1000mA and AC 10A.
-
Product
ION Meters
-
GAOTek offers a wide selection of ion meters for precise calculation of number of ions in various kinds of solutions. These devices determine whether the solutions have positive or negative ion charge. A solution of known concentration is accurately prepared, and its mV value is plotted on a graph of mV vs. concentration to determine the corresponding unknown concentration. These devices are durable and easy to use portable field instruments.
-
Product
Field Meter
AP 201 Plus
-
The AP201 Plus field meter with total coverage of terrestrial TV bands, cable TV (CATV), 1st IF satellite and, if the relative option is inserted, the return channel 5-65 MHz.
-
Product
Vibration Meters
-
Portable vibration analyzer for equipment diagnosis and on-site measurements. Vibration meter with FFT analysis function.
-
Product
Metering ICs
-
Smart metering Analog Front End (AFE) ICs offer high accuracy when measuring DC and AC energy down to extremely low currents typical of home appliances in standby mode.
-
-
Product
Milliohm Meter
-
Utility area: measurement of secondary transformer winding ;measurement of division switch for sufficient low-ohm value
-
Product
Ultrasonic Meters
E-Series
-
E-Series Ultrasonic water meters from Badger Meter use solid-state technology in a compact, totally encapsulated, weatherproof, and UV-resistant housing, suitable for residential and commercial applications. Equipped with an easy-to-read, 9-digit LCD display, the ultrasonic meter reports consumption, rate of flow, reverse-flow indication, and alarms. With no moving parts, the E-Series Ultrasonic meter improves reliability and has greater extended low flow accuracy compared to mechanical meters.
-
Product
Ph/Conductivity Meters
-
Researchers, technicians, and environmentalists use the pH meter to measure the amount of acid, or hydrogen-ion, in a solution or semi-solid.
-
Product
Thickness Meter
-
Shenzhen Graigar Technology Co.,Ltd.
An ultrasonic thickness gauge is a measuring instrument for the non-destructive investigation of a material's thickness using ultrasonic waves.
-
Product
Light Meters
-
Our light meters are designed for simple and accurate results in an industrial setting. Whether you are checking work spaces, parking lots, or baseball fields for safe levels of lighting or measuring for testing design compliance, a light meter from Sper Scientific will get the job done. Obtain precise UV, FC or Lux measurements, in multiple light measurement ranges. These light meters are designed for use in work spaces, labs, schools, outdoor studies, optics, home inspections, and many others. In addition, you may use these meters to check compliance with ANSI/NFPA 101 (standards for emergency & exit lighting).
-
Product
VU Meters
-
Hoyt Electrical Instrument Works Inc.
The Retro Audio Level analogue panel meters complement the proven and popular Presentor series. The meters offer a performance not significantly different from full specification vu meters to meet today's specific audio market requirement for both quality and distinctive 'retro' styling at an affordable price.
-
Product
Strength Meters
-
An instrument that measures the electric field strength emanating from a transmitter.
-
Product
Deceleration Meter
-
Maschinenbau Haldenwang GmbH & Co. KG.
Is used for mobile brake testing
-
Product
RC Meters
-
Provides the. capacitance to be measured at a frequency which is reciprocal to the. product of the discharge resistance and the measured capacitance.
-
Product
3CT Method Clamp Tester
MCL-4000F
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*3CT method enabled easy AC leakage current measurements with simple clamping of each phase conductor by 3 CTs or 4 CTs.*Use 4 CTs for 3phase/4wire power system.*Load current measurements for each phase conductor up to AC 800A.*Filter rejection for high frequency noise.*DC mV output for recorder.
-
Product
Multifunction Meter
-
Easy navigationEvent recording with time stamp (all basic & power parameters)Unbalance load and voltage with calculated neutral currentDynamic communicationOptional digital output for all basic and power parameters
-
Product
Voltage Meter
МН32С
-
The mezzanine module (mezzanine) МН32С is designed to measure instantaneous voltage values over thirty-two differential channels.
-
Product
Light Meters
-
A light meter is a very sensitive electronic measuring device used to help monitor the illumination of any given area. Most light meter devices are small in size, simple to operate and equipped with an easy-to-read lighted screen made of special glass. Typically, a heavy-duty housing protects the light sensor inside the light meter from damage. A light meter is used for measuring brightness in lux (lx), foot candle (fc) or candela per square meter (cd/m²)measuring units. Some light meter devices are equipped with an internal memory or data logger to record and save measurements. The measurement of light intensity with a light meter is becoming increasingly important in the workplace due to safety concerns. Light measurement is also necessary to determine the best location and angle when installing and adjusting solar panels.
-
Product
TSS Meter
LD-LTSS-A10
-
TSS meterLD-LTSS-A10is a tabletop meter with a dual-beam infrared scattered light photometerdetection system for enhanced stability. Built-in self-diagnosis function to ensure dataaccuracy. Optional cleaning brush for automate cleansing function to reduce the sensormaintenance.
-
Product
AC/DC Mini Digital Clamp Tester (CE)
M-290RMS
-
MULTI MEASURING INSTRUMENTS Co., Ltd.
*30mmφ CT window and ultra compact size.*Conform to IEC safety requirements.*True rms reading for ACA and ACV.*Data-hold function and auto power off.*Auto zero adjustment for DC current offset.
-
Product
Georesistive Meter
RM1
-
RM1 is a compact and versatile georesistive meter with 24 bit acquisition card. The console keypad allows easy and immediate access to all the main functions even in the most critical environmental conditions.
-
Product
Light Meters
LXP-2
-
The digital light meter is a precision instrument used to measure illuminance (Lux, footcandle) in the field. It is meet CIE photopic spectral response. It is fully cosine corrected for the angular incidence of light. The illuminance meter is compact, tough and easy to handle owing to its construction. The light sensitive component used in the meter is a very stable, long-life silicon photo diode and spectral response filter.
-
Product
Backshell, iCon, Receiver, with Large Cable Clamp
310113794
-
This receiver backshell is used with the iCon Receiver and is not mounted to a rack or panel. It provides protection for exposed wiring and is ideal for use together with the iCon ITA for cable-to-cable applications.
-
Product
Current Meters
-
Measure current using either "Average responding" meters reading linear loads or "True RMS" meters measuring non linear loads.
-
Product
ITA, iCon, Extended Cable Clamp
410123115
-
This iCon ITA includes an extended cable clamp to accommodate larger cable bundles. The maximum cable bundle area = 1.97 " sq. or a 1.58"/40.13mm diameter bundle. The clamp may be inverted for smaller cable bundles.Please note: This ITA does not offer an increased bend radius that may occur with a larger cable bundle radius. Larger bend radius is offered by the iCon XL, p/n 410123232.
-
Product
Metra ACDC Clamp 1000A
-
Metra Clamp 1000A /300A measures important electrical parameters like AC Current, AC Voltage, DC Voltage. It also features Capacitance, Ohm & Continuity, frequency, Duty cycle and temperature meas-urement.
-
Product
Self testing clamps with Visual Indication
Bond-Rite EZ
-
The Bond-Rite EZ is an easy to use hand-held portable static bonding device that can quickly and securely establish and verify an equipotential bond between equipment for operations conducted in hazardous locations.
