D-Sub
D-Subminature Connector Also known as: DSub
-
Product
PXI Programmable Resistor Module
Module
PXI Programmable Resistor Modules are wellsuited for simulating environmental conditions in hardwareintheloop(HIL) validation. The software included provides a simple user interface that accepts inputs in units of temperature or resistance, and configures the resistance across each channel. Each module uses a 37pin DSUB connector on the front panel, as well as a 2x2 MicroFit connector for easy connection to a PXI Digital Multimeter(DMM).
-
-
Product
DB37 Cable
PCL-10137
-
Double-shielded cable with 37-pin D-sub connectorsD-Sub 37 pin male, Blue x 2Tinned and strand copper wire with drain wire x 1Aluminum/Mylar foil and braided copper double-shielded cableIsolated P.V.C. jacketUL20397 approvedIvory Color
-
Product
9-Pin D-SUB Female with 2-Pin Power Screw Terminal Female to 9-Pin D-SUB Female, Single Termination CAN and LIN Cable
782579-02
CAN Cable
The DB9F-PT2F-DB9F CAN Cable, sometimes referred to as CAN Cable (with power terminals), connects C Series CAN Interface Modules, C Series LIN Interface Modules, or C Series Multiprotocol Interface Modules that have ports requiring external power with external CAN signals. The screw terminals on the cable allow for the direct wiring of power and ground to the port on the CAN interface. This cable is compatible with high-speed, flexible data-rate, and low-speed/fault tolerant CAN signals and is available with or without termination.
-
Product
Micro Dsub GPIB Cable Adapter For PZ2100A (0.25m)
-
The Keysight PX0110A converts MicroD25 GPIB to standard GPIB. It supports the Keysight PZ2100A.Standard GPIB to MicroD25 Cable length: 0.25 meter Compatible with the PZ2100A
-
Product
37-Pin D-SUB Female To 4 7-Pin Tajimi Female, C Series Strain/Bridge Input Module Multifunction Cable
199254-01
Multifunction Cable
SH37F-Tajimi Shielded Cable, 1M
-
Product
PCI Express Digital I/O Boards
PEX-P8R8I
-
PCI Express Board with 8 Isolated Digital Inputs and 8 Relay Outputs. Includes one CA-4002 D-Sub connector and Software Development Kit with Demo Programs
-
Product
Cable Assembly, Receiver, TriPaddle/Micro Coax, 36", 2 9-Pin Female D-Subs, and 2 SMB Plugs
540278010259
Cable Assembly
Cable Assembly, Receiver, TriPaddle/Micro Coax, 36", 2 9-Pin Female D-Subs, and 2 SMB Plugs.
-
Product
PCI Digital I/O Boards
PCI-P16C16
-
16 Channel Isolated Digital Input, 16 Channel Open-Collector Output Board. Includes CA-4037W cable and two CA-4002 D-Sub connectors
-
Product
Cable Assembly, Receiver, 20", QuadraPaddle, 78-Pin ML D-Sub
540116020140
Cable Assembly
Cable Assembly, Receiver, 20", QuadraPaddle, 78-Pin ML D-Sub.
-
Product
PCI Digital I/O Boards
PCI-P16POR16
-
16 Channel Isolated Digital Input, 16 Channel PhotoMos Relay Output. Includes CA-4037W cable and two CA-4002 D-Sub connectors
-
Product
9-Pin D-SUB Female to 9-Pin D-SUB Female FlexRay Cable
198290-01
FlexRay Cable
SHDE9F-DE9F-FX Flexray Cable, No Termination, 1M
-
Product
25-Pin D-SUB Female to 25-Pin D-SUB Male, Twisted Pair Multifunction Cable
192568-01
Multifunction Cable
SH25F-25M-1 25-Pin Female to Male Shielded I/O Cable, 1 m
-
Product
sbRIO-9221, Non-Enclosed, ±60 V, 800 kS/s, 12-Bit, 8-Channel C Series Voltage Input Module
781116-01
Voltage Input Module
Non-Enclosed, ±60 V, 800 kS/s, 12-Bit, 8-Channel C Series Voltage Input Module - The sbRIO‑9221 performs single-ended analog input. The wider voltage range makes this module well suited for industrial-level, automotive, or even smaller-cell battery measurements. There are two connector options for the sbRIO‑9221: a 36‑position spring‑terminal connector and a 37‑position DSUB connector. Non-enclosed modules are designed for OEM applications.
-
Product
15-Pin Female D-SUB to 15-Pin Female Screw Terminal, DIN Rail Terminal Block
785334-01
Terminal Block
15-Pin Female D-SUB to 15-Pin Female Screw Terminal, DIN Rail Terminal Block - The 15-Pin D-SUB to Screw Terminal provides a DIN rail terminal block for CompactDAQ and CompactRIO controllers.
-
Product
Cable Assembly, Receiver, 36", TriPaddle, 50 Pin FML D-Sub
540111020203
Cable Assembly
Cable Assembly, Receiver, 36", TriPaddle, 50 Pin FML D-Sub.
-
Product
68-Pin D-SUB Female to 68-Pin D-SUB Female, Twisted Pair, Shielded Digital Cable
183432-05
Digital Cable
68-Pin, Female D-SUB to 68-Pin, Female D-SUB, Twisted Pair, Shielded Digital Cable - The SH68-68-D1 Digital Cable connects NI 6533/4 digital instruments and NI 660x or 661x counter/timer modules to 68-pin accessories. This shielded cable features twisted pairing and is offered in different lengths.
-
Product
Cable Assembly, Receiver, TriPaddle, 36", 37-Pin Female D-sub and 4 POS Micro Fit Connector
540016070201
Cable Assembly
Cable Assembly, Receiver, TriPaddle, 36", 37-Pin Female D-sub and 4 POS Micro Fit Connector.
-
Product
CANBus Communication
PISO-CAN400U-D
-
The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN400/CAN200 can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 5-pin screw terminal connector or 9-pin D-sub connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN400/CAN200 uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.
-
Product
Breakout Box
T1000-37
-
T1000-37 breakout box is our most versatile model, using dual 37 pin D-Sub connectors for signal capture or monitoring. Dual connectors provide a total of 74 test points plus a ground jack. All test points use standard size 4mm banana jacks. Test points may be connected using shorting banana cable to allow signal continuity. Ideal for continuity measurements, isolation testing, and signal capture.
-
Product
25-Pin Male D-SUB to 10-Pin Female COMBICON, Shielded Multifunction Cable
190654-02
Multifunction Cable
Cable, 10 Pos Combicon to DB 25, 2 Meters
-
Product
1.5-m, 78-pin Dsub Cable
Y1137A
Switch Cable
The Y1137A is a M/F twisted-pair cable with outer shield. The 300-V cable provides a direct connection for the Keysight multifunction switch / measure mainframe and modules. Some modules require two cables.
-
Product
ISA Isolated Digital I/O Boards
ISO-P64
-
The ISO-P64 has 64-channel isolated digital input board, arranged into four isolated banks. Each input channel use a photo-coupler input which allows either internal power supply or external power selected by jumper. Isolated input channels 0~15 are designed into group A, channels 16~31 are designed into group B, Isolated input channels 32~47 are designed into group A, channels 48~63 are designed into group B. The power supply of the input port may use the external power or the power from the PC side using DC to DC converter. The board interface to field logic signals, eliminating ground-loop problems and isolating the host computer from damaging voltages. The ISO-P64 has one 37-pin D-sub connector and one 40-pin header. The 40-pin to D-sub 37 flat cable is used to fix with the case. The user can connect the digital signal through the second D-sub connector. Each D-sub connector contains 16 inputs channel and 16 output channel.
-
Product
Cable Assembly, Receiver, QuadraPaddle, 48", 2 50-Pin Female D-Subs
540111040640
Cable Assembly
Cable Assembly, Receiver, QuadraPaddle, 48", 2 50-Pin Female D-Subs.
-
Product
68-Pin VHDCI Male to 8-Port 9-Pin D-SUB Male, Serial Cable
197546-01
Serial Cable
68 POS VHDCI Conn to Eight 9 POS D-SUB, RS 485, 1M
-
Product
Cable
RCONQPMC-2
-
RCONQPMC-2 - Transitions from a SCSI-68 pin connector to four CJ70 Twinax, 3 lug, 1553 cable jack ends and one D-Sub 50 pin connector for additional I/O.
-
Product
PXI General Purpose 2A Relay Module 16xSPDT, 50 D-sub
40-131-001
Relay
These low cost, general purpose electromechanical relay cards are capable of switching voltages up to 300VDC/250VAC and current up to 2A. They are suitable for use where reed relay based switching cards do not have sufficient voltage or current carrying capability. Applications include the switching of medium power AC and DC loads, or slave switching larger relays, contactors or solenoids. Connections are made to the card via a front panel mounted 50 pin D-Type connector plug.
-
Product
Cable Assembly, Receiver, 20", TriPaddle, to 25 Pin Female D-Sub
540014010101
Cable Assembly
Cable Assembly, Receiver, 20", TriPaddle, to 25 Pin Female D-Sub
-
Product
Cable Assembly, Receiver, TriPaddle, 72", 37-Pin Female D-sub and 4 POS Micro Fit Connector
540016070501
Cable Assembly
Cable Assembly, Receiver, TriPaddle, 72", 37-Pin Female D-sub and 4 POS Micro Fit Connector.
-
Product
Board Accessories
DN-25/N (without Din Rail Mount)
-
DN-20 is a Screw Terminal Board for PC Based I/O Boards with or without din rail mounts. It is an I/O Connector Block with one 9-Pin and one 25-Pin D-Sub Connector.
