Ultraviolet
Ultraviolet light is in the wavelength between 380-10 nm. Also known as: UV
See Also: UVA, UVB, UV, UVC, Electromagnetic Radiation
-
Product
Polarizers
-
Achieves high contrast and high transmission for the UV, VIS, NIR, and Mid-IR ranges with a wide acceptance angle of ±20°. The prolate silver nano-particles are embedded inside the glass which results in high durability, wide temperature range, and easy cleaning.
-
Product
RGB Digital Fiberoptic Amplifier
CZ-V20 Series
-
SUPER HIGH POWER RGB sensor Industry's best color differentiation. High resolution amplifier for triple 16-bit calculation. New Luster Detection Sensor Head. Dual digital display & Direct access. New UV sensor head for fluorescent Detection. Three detection modes for every target [Super I / C' / C+I]
-
Product
Trace-Level UV Fluorescence SO2 Analyzer
Model T100U
-
Teledyne Advanced Pollution Instrumentation
The Model T100U Trace-level SO2 analyzer has been developed specifically to address the challenges of low level monitoring as required, for example, in the US NCore network. It uses the proven UV fluorescence principle, and is designed to allow ultra-sensitive SO2 measurements while still meeting the requirements for use as a US EPA compliance analyzer.The analyzer uses both the light and dark phases of the pulsed UV light source to continuously detect and correct for electronic noise, giving exceptionally stable and sensitive performance. A separate UV detector allows the instrument to continuously correct for variations in lamp intensity. Exceptional stability is achieved with the use of an optical shutter to compensate for PMT drift, and a reference detector to correct for changes in UV lamp intensity. A hydrocarbon "kicker" and advanced optical design combine to prevent inaccuracies due to interferents.
-
Product
EYE Super UV Tester
-
UV rays are the greatest cause of product deterioration. This unique system dramatically intensifies the deterioration acceleration caused by UV rays. It can achieve an acceleration factor greater than 100 times normal sunlight, producing material effects equivalent to extended outdoor exposure. Its compact size makes it ideal for research and development testing of paints, inks, pigments and fibers as well as plastics.
-
Product
UV Solar Simulators
-
UV Solar Simulators - please contact the company directly for more information.
-
-
Product
Environmental Test Chambers
-
Dongguan Kejian Instrument Co., Ltd.
UV accelerated weathering test chamber simulates damaging effects of long term outdoor exposure of sunlight, heat, moisture on materials and coatings. It exposes specimen to varying conditions of weathering- ultraviolet radiation, moisture and heat to test the performance and improve the quality.
-
Product
UV Plasma Sources
UVS300|UVS 10/35
-
The UVS300 and UVS 10/35 are UV Plasma sources with high intensity, working with different gases.
-
Product
Ultra-Stable, High-Power, CW Laser in the UV & Visible
SolsTiS Titan
-
SolsTiS Titan is based on M Squared’s award-winning SolsTiS CW Ti:Sapphire laser platform. It’s a fully-automated, high-power, single-frequency laser operating in the UV and Visible and offers unprecedented stability and reliability. Titan is simple to operate and integrate into diverse industrial and deep-tech application scenarios and delivers dramatic cost savings over legacy laser technologies.
-
Product
Radiometer/Photometer Kit
AccuMAX™ Series
-
Single detector with dual sensors measures both ultraviolet and visible light. Complies with ASTM specifications for MPI and FPI. Specially engineered for NDT applications. The AccuMAX XRP-3000 radiometer/photometer kit uses a dualwavelength UV-A/VIS sensor detector to measure both ultraviolet and visible light. Featuring automatic zeroing, integration and signal hold, the unit provides accurate readouts for UV, visible irradiance or radiance.
-
Product
Wet Oxidation TOC Analyzer
TOC-VWP
-
Phosphoric acid and the oxidant (persulfate) are added to the sample, which is heated under UV illumination to convert the TC in the sample to carbon dioxide. This carbon dioxide flows with the carrier gas via the dehumidifier into the NDIR sample cell. The area of the carbon dioxide peak signal is measured and this peak area is converted to TC concentration using a pre-prepared calibration curve.
-
Product
UV Index Measurement
-
The sglux UV-Index sensors measure the UVI with a worldwide unique low measurement uncertainty of less than 5 %. This makes our sensors compliant to the highest measurement precisions class one according the DIN/EN 5031-11, chapter 8. Since 2018 our product UV-Cosine_UVI (ERYCA) is appointed for public authority tasks: The German Federal Office for Radiation Protection (BfS) services 27 measurement points in Germany for public information of the daily UV-Index. Twenty of these points (Andernach, Chieming, Duderstadt, Fichtelberg, Genthin, Giessen-Wettenberg, Schauenburg-Kassel, Langen, Lueneburg, Munchen-Neuherberg, Norderney, Belm/Osnabrueck, Schauinsland, Tholey, Todendorf, Waldhof-Falkenstein, Waldmuenchen, Wurmberg, Zingst and Zirchow) use the sglux ERYCA to obtain the local UV-Index value. In 2017 ARPANSA (Australian Government’s primary authority on radiation protection and nuclear safety) began replacing the existing biometers with SiC photodiode UV sensors (sglux ERYCA) at all network sites. There are currently thirteen measurement sites in Australia that have been upgraded to the new sensors.
-
Product
Energy Meters
Rj-7600
-
The Rj-7610 Single Channel Energy Meter works with a variety of probes – pyroelectric, silicon, and thermopile – to measure true energy per pulse from single-shot to 40 Hz, picojoules to Joules, UV to far-IR. Sets of 10 or 100 pulses can be statistically analyzed (mean, minimum, and maximum energies, standard deviation), and data can be transferred to computer via the IEEE-488 GPIB computer interface or using the 0-10 VDC analog outout.
-
Product
Streak Camera
OptoScope SC-10 systems
-
SC-10 systems are based on the SC-10 main unit and cover a very large range of applications thanks to their flexibility. With a time resolution of 2 ps, a very high temporal resolution streak system is available. The main unit itself uses a fused silica input window, maintaining sensitivity well into the UV range. Deflection units for triggered and synchroscan operation are available. The configuration with a second deflection unit for extension with an orthogonal time axis is also possible. SC-10 systems are well suited for applications in the field of time-resolved spectroscopy and offer a wide range of options for optical coupling.
-
Product
UV Accelerated Weathering Tester
TF424
-
TESTEX Testing Equipment Systems Ltd.
UV Accelerated Weathering Tester, age tester, to simulate the testing environment of sunlight, rain, and dew to reproduce the effect of sunlight with fluorescent ultraviolet lamps, providing rain and dew with condensing humidity. The aging of the specimens is accelerated by exposing the samples to alternating cycles of light and moisture at a certain temperature.
-
Product
EUV Lithography
NXE systems
-
NXE lithography systems are used in high-volume manufacturing of advanced Logic and Memory chips. The first systems to use ASML’s novel 13.5 nm EUV light source, they print microchip features with a resolution of 13 nm, which is unreachable with deep ultraviolet (DUV) lithography. Chipmakers use our NXE systems to print the highly complex foundation layers of their 7 nm, 5 nm and 3 nm nodes. Read about how EUV lithography went from imagination to reality.
-
Product
Plastic Testing Machines
-
Infinity Machine International Inc.
Plastic Testing Machines by Infinity Machine International Inc. - for applications such as constant temp adhesion tester, plastic testing equipment heating distortion resistance testing, adhesive tape holding power test machine, plastic impact resistance, impact resistance for plastic pipes, salt spray plastic testing machines, uv accelerated weather plastic testers, and more.
-
Product
Pulse Characterization Sensors
-
Pulse Characterization Sensors provide the ability to see and measure the temporal characteristics of pulsed and CW laser beams. Ophir Fast Photodiode Detectors are designed to convert optical signals into electrical signals which are then measured with third-party instrumentation such as oscilloscopes and spectrum analyzers. Accessories are available to connect to IS6 integrating spheres or fiber optic cables. Attenuating filter accessories are also available to increase their dynamic range. Different models offer silicon, UV enhanced silicon and InGaAs PIN photodiodes, covering a combined spectral range of 193 nm to 1700 nm. Rise times range from 25 picoseconds to 3 nanoseconds. The fast rise times are achieved by an internal reverse bias voltage circuit. Power is supplied by internal batteries and/or an external power supply depending on the model. Detectors should be connected to a 50Ω impedance in order to maintain their nominal rise times. They can be connected to higher impedance loads, but this will result in a significant increase in the rise time. If higher output voltage is required, it is recommended to connect the detector to a trans-impedance amplifier with an Input impedance of 50Ω
-
Product
Solar Spectrum Test Chamber / Solar Radiation Test Chamber
-
WEIBER Solar Spectrum Test Chambers are one of solutions to be utilized in large scale PV testing program. We offer customized as well as standard multidimensional test program for PV modules in reasonable prices. This system delivers the weathering stress representative of long term outdoor exposure.Our flexible system can be designed according to our test requirements, to suit environmental test conditions like volume, temperature, humidity solar radiation intensity and other measuring instruments. Weiber provide Solar Radiation Test Chamber.WEIBER solar test system are recognized for superior solar simulation environmental Testing, evaluating outdoor use product reliability, quality & safety. This technology allows for very high concentrations of UV energy without excessive heating of test samples. Custom mounting and cooling can be added depending upon specific material exposure requirements. MHGs (metal halide global lamps) are used as radiation source. Weiber provide Solar Simulation Test Chamber.
-
Product
Xenotest
440
-
Atlas Material Testing Solutions
The Xenotest 440 is a highly versatile xenon weathering instrument for a variety of materials. Designed for fast and economical testing, the Xenotest 440 utilizes XenoLogic™, a revolutionary new twin-lamp operating technology which enables high irradiance levels of 120 W/m2 of total UV radiation.
-
Product
SensLine Spectrometers
-
The SensLine series of products is Avantes’ response to customers who require higher performance demanding spectroscopy applications such as fluorescence, luminescence, and Raman. The SensLine product range includes several high-sensitivity, low-noise spectrometers. Several of these instruments feature back-thinned detector technology, some of which feature our high-performance, thermoelectrically cooled detectors. The other models feature standard CCDs, upgraded to high-performing instruments as a result of Avantes’ unique detector cooling technology. The back-thinned CCD detectors featured in the SensLine series are high-quantum efficiency detectors with excellent response in the ultraviolet, visible, and near-infrared range from 200 to 1160 nm.
-
Product
Online UV Analyzers
-
Accurately monitor performance of UV filtration systems with online UV analyzers. Our online UV analyzers use UV254 technology to provide accurate water quality tests. Help ensure safe municipal wastewater with trusted wastewater UV analyzers you can count on.
-
Product
Handheld Imaging System
SpectraScanner TM
-
The SpectraScanner is the latest product from Oculus Photonics, released in July 2012. The SpectraScanner is a handheld imaging system that has all the functionality of the UVScanner, plus an additional near-infrared viewing capability. This dual-band imager uses two separate cameras, one tuned for longwave ultraviolet, the other for near-infrared.
-
Product
Calibration Services
-
For over 25 years, OAI (Optical Associate Inc.), is the leader in NIST traceable calibration of instruments for measuring Ultra Violet (UV) light. Originally designed to meet the demanding needs of the semiconductor wafer fabrication industry, OAI developed the most repeatable NIST traceable calibration in the industry.
-
Product
Custom Solutions for UV Intensity Meters & Radiometers
-
OAI offers custom designed solutions built to your unique specification.
-
Product
Portable Gas Calibrator
Model T750
-
Teledyne Advanced Pollution Instrumentation
The Model T750 is a portable, microprocessor based calibrator for precision gas analyzers. Using highly accurate mass flow controllers combined with compressed sources of standard gases, calibration standards are provided for multipoint span and zero calibrations. The T750 is housed in a high-density, molded travel case which includes an integral handle and wheels for durability and ease of use in the field.The Model T750 can be equipped with an optional UV ozone generator for accurate, dependable ozone calibrations, and production of NO2 when blended with NO gas in the included, internal gas phase titration (GPT) chamber. An optional photometer allows even more precise control of the ozone generator giving accurate and dependable ozone calibrations and enhanced GPT. A number of calibration sequences may be programmed into the non-volatile memory of the Model T750, covering time periods up to a year.
-
Product
LED Spot Type UV Curing Systems
AICURE UJ30/35
-
Panasonic Industrial Devices Sales Company of America
The compact UJ30/35 UV Curing System can be equipped with up to four individually controlled LED heads. Different types of UV-LED heads are available with an irradiation wavelength of either 365nm, 385nm or 405nm. The Controller allows for external contact inputs or PLCs for automated applications.
-
Product
Light Intensity Sensor
ENVIROMUX-LIS
-
Detects and measures the luminous intensity of light. Ideal for monitoring unmanned closets, telecom rooms, remote data rooms, or other low traffic facilities. Applications from 0 to 128,000 lux. Human eye response (540 nm peak sensitivity). IR and UV rejection. RJ45 connector. Supports CAT5/5e/6 cable up to 1,000 ft. (305 m). Powered by ENVIROMUX-2D/5D/16D. Regulatory approvals: CE, RoHS. Compatible with ENVIROMUX-2D/5D/16D.
-
Product
Environmental Test Chamber
-
Shenzhen Bonad Instrument Co., Ltd.
Climatic Test Chambers are also referred to as environmental test chambers, which are the general name of various test equipment used to simulate the natural environments of raining, high temperature, low temperature, dewing, salt mist, illumination, dusting, etc. There are kinds of testers including constant temperature chamber, constant humidity chamber, ozone aging test chamber, UV accelerated weathering tester, vacuum hot air oven, salt spray chamber, steam aging tester, rain test chamber, dustproof test chamber, ventilation aging chamber, xenon lamp weathering test chamber and so on. BONAD provides various environmental test chambers. You are welcome to contact us. BONAD will provide you with professional technical consultation and high-quality testing equipment.
-
Product
Luminescence Sensors
-
Luminescence sensors detect visible and non-visible marks that illuminate when using ultraviolet (UV) light. Fluorescent material and marks are reliably detected independently of their pattern, colors or surface conditions on any material. Luminescence sensors emit UV light with a wave length of approximately 375 nm. Fluorescent substances convert the UV light into long-wave visible light, which is then received and evaluated by the luminescence sensor.
