Vapor
-
product
Portable Spectrometer / Portable Spectrum Analyzer
Optoplex's portable spectrometer / portable near-infrared optical spectrum analyzer (OSA) / mini spectrometer is a valuable spectral module in the Process Analytical Technology (PAT) applications. Portable spectrometer acts as a stand-alone spectral engine, imaging and measuring, through a rapid and nondestructive process, a wide range of vapor, liquids and solids through transmission and diffuse reflection.
-
product
Gas and Vapor Delivery Systems
In thin film deposition, high-quality results start with how process gases are delivered, as they help create the stable environment needed for consistency by controlling flow, pressure and composition to support processes like ALD, CVD, and PVD. Advanced semiconductor devices developed for the most advanced computing processes, such as AI and edge computing, need the ultra-high-purity environments of our gas and vapor deposition delivery systems.
-
product
Reach-In Altitude Test Chamber
Weiber Altitude Test Chamber combine temperature and altitude to test basic components or subassemblies designed for use in a variety of industries. With altitude test chambers, user can control the temperature environment for testing while simulating various altitudes from site level to 10,400 meters (25kPa). Altitude testing may be continued without temperature control up to 600,000 meters (0.1 kPa).High Low Temperature Altitude Test Chamber is used to test temperature and low-pressure altitude conditions simultaneously. Two common applications of High Low Humidity Altitude Test Chamber are testing of avionics or other aerospace equipment to simulate actual conditions, and simulate high-altitude conditions found in mountainous regions or other regions. All models are factory tested, with an ergonomic and maintenance cum user-friendly design. These CE approved test chambers are created with multi-layered insulation with double vapour barrier is of low 'K' factor, high density and of non-hygroscopic in nature. Weiber test chamber are made in accordance with the international standard. Weiber Test Chambers are GMP complaints and are also ISO and NABL certified.
-
product
Flash Point Testers
Flash point is the lowest liquid temperature at which a test flame causes sample vapors to ignite. Fire point is the temperature at which the test flame causes the sample to ignite and remain burning for ≥5 seconds.
-
product
Combustible Trip Amplifier Module
TA102A
The TA102A is a single-channel Combustible Gas Trip Amplifier Module designed for use with one General Monitors intelligent transmitter to monitor combustible gases and vapors within the lower explosive limit (LEL) and provide status indication and alarm outputs. Microprocessor-based electronics allow all options to be user selectable through a front panel interface (mode / select switch and digital display).
-
product
Class A Ovens
Gruenberg ovens can be designed as Class A ovens to conform to OSHA, NFPA 86A, Factory Mutual (FM) and Factory Insurance Association (FIA) requirements. Class A ovens are equipped with a high exhaust rate: because the heating elements are an ignition source so a high exhaust rate is needed to dilute the volatile vapors below the “lower explosive limits.” As a result, the heating elements’ kW must be sufficiently increased to compensate for the heat loss caused by the above-normal exhaust rate. In addition, for a Class A oven to be energy efficient, the additional kW required must be carefully calculated according to solvent load and operating temperature requirements.
-
product
High Temperature Absolute Pressure Transducers
Our high temperature Baratron® capacitance manometers are controlled to temperatures of 150°C or higher for use use in demanding semiconductor manufacturing vacuum processes such as metal etching and nitride film chemical vapor deposition (CVD).
-
product
Gauge Siphons
Parker's gauge siphon and swivel offerings include compact siphons that serve as thermal barriers to protect instruments from harmful vapors. They are available with safety excess flow check/snubbers to avoid pressure-surge damage.
-
product
Laser Type PM Sensor
SN-GC
Panasonic Industrial Devices Sales Company of America
Panasonic’s Laser Type Particulate Matter Sensor has a very small footprint of W37 x D37 x H12 mm, and can be used to detect a wide variety of particulate matter including but not limited to dust, fly ash, soot, smoke, aerosols, fumes, mists and condensing vapors, solid fuels, construction materials, cooking/smoking of plant matter, fireplaces and furnaces, house/forest fires, waste incineration and much more.
-
product
Auto Water Vapour Permeability Tester
TESTEX Testing Equipment Systems Ltd.
Auto Water Vapour Permeability Tester, to determine the water vapour permeability of various textile and garment fabric, coating fabric, composite, sportswear and industrial fabrics. Auto Water Vapour Permeability Tester complies with ASTM E96, ISO8096, BS 3424, etc.
-
product
Portable Sulphuric Acid Dewpoint Temperature Monitor
The fuels used in boilers, such as coal, heavy oil and natural gas, contains S. during the combustion process, S and O₂ form SO₂, and a small amount of SO₂ is converted into SO₃ under catalysis of Fe₂O₃, V₂O₅ and other catalysts. Under normal circumstances, the volume of SO₃ in the boiler flue gas is 1×10-6～50×10-6, and the water vapor is about 10%. When the temperature of the flue gas is below 200°C, SO₃ and the water vapor are completely combined into H₂SO₄ vapor. A small amount of H₂SO4 vapor will significantly increases the acid dew point. When the surface temperature of the boiler heat exchange equipment is lower than the flue gas acid dew point, the H₂SO₄ vapor will condense on the surface to become sulfuric acid solution with a concentration of about 80%, which will adhere to the surface of the heat exchanger and cause acid corrosion. Typical equipment that is prone to corrosion includes air preheaters, induced draft fans and flue walls.
-
product
Moisture Permeability Tester
DRK501F
Shandong Drick Instruments Co., Ltd.
The principle of moisture permeable cup weighing method is to measure the transmittance of water vapor to film, sheet, paper and other materials by weighing the weight of moisture permeable cup.
-
product
Adaptive Infrared Imaging Spectroradiometer
AIRIS
The Adaptive Infrared Imaging Spectroradiometer (AIRIS) has been developed for real-time standoff detection of chemical vapors and biological aerosols as well liquids and solids (such as chemical agents and trace explosive residues) on surfaces.
-
product
Dew Point Logger Sensor
NUL-245
This sensor measures temperature and humidity in a volume and gives the temperature below which the water vapor in that volume of air (at a constant barometric pressure) condenses into liquid water (the dew point).
-
product
Dynamic Vapor Sorption Analyzer
IGAsorp
The IGAsorp is a fully automated compact benchtop DVS analyzer, for fast and accurate vapor sorption measurements using the dynamic flow technique for water and organic solvents. Measured vapor uptake isotherms and kinetics are used to characterize, test and evaluate materials in precisely defined environmental conditions.
-
product
Leaf Porometer
This is steady-state porometer. the principle is the vapor exchange between leaf and air, use the mothod of air exchange, measure the relevant humidity, temperature of in the leaf, thus get the Transpiration speed of the leaf, and measure the temperature of the leaf , calculate the
-
product
Open Path CO2/H2O Analyzer
LI-7500DS
The LI-7500DS is designed for high-speed CO2 and water vapor measurements in ambient air. Lower power and maintenance requirements make it ideal for field deployments.
-
product
Industrial Gas Detectors
Seitron designs and manufactures detectors for methane, LPG, gasoline vapours and carbon monoxide (CO) for commercial and process industry use. Our detectors provide three communication protocols 4..20mA, Modbus and S-Bus (a proprietary protocol derived from Modbus). You can also choose between two types of housings: polycarbonate for industrial use or ATEX-certified for the installation of detectors in ATEX-classified areas.
-
product
Mid-Range Gas Filter Correlation CO Analyzer
Model N300M
Teledyne Advanced Pollution Instrumentation
The Model N300M is a microprocessor-controlled analyzer used to determine the concentration of carbon monoxide (CO) in a sample gas. The analysis method is based on the Beer-Lambert law.The N300M uses Gas Filter Correlation (GFC) to overcome the interfering effects of various other gases (such as water vapor) that also absorb IR. The analyzer passes the IR beam through a spinning wheel made up of two separate chambers: one containing a high concentration of CO known as the reference, and the other containing a neutral gas known as the measure. The concentration of CO in the sample chamber is computed by taking the ratio of the instantaneous measure and reference values and then compensating the ratio for sample temperature and pressure.
-
-
product
Greenhouse Gas Analyzer
GASERA ONE GHG
Many chemical compounds are present in Earth’s atmosphere and are capable of acting as greenhouse gases capable of absorbing and emitting infrared radiation emitted by Earth. Many of the gases such as carbon dioxide, methane, nitrous oxide and water vapor among others, occur naturally in the atmosphere and also have anthropogenic (man-made) sources. Methane (CH4) is the second most important greenhouse gas in terms of concentration and impact on the climate.
-
product
Quadrupole Mass Spectrometer for Residual Gas Analysis
RGA Series
Systems for the examination of components present in a vessel or evolved from a process. HALO RGA – for residual gas analysis. 3F Series RGA – triple filter mass spectrometers for analytical applications. 3F-PIC – pulse ion counting detection for fast event studies. Measures the concentration of gases and vapours in real time.
-
-
product
Spectroradiometers For UV Curing
Spectroradiometers and radiometers for UV curing & other high intensity UV applications. E.g. the measurement of mercury vapor lamps and or UV LEDs.
-
product
Water Vapour Absorption Tester
UI-FT18
Water Vapour Absorption Tester is suitable to test water vapour absorption of all kinds of leather.
-
product
Gas Monitor
Ultima® XIR
The microprocessor-based, infrared Ultima XIR gas detector is precisely engineered to continuously monitor for combustible gases and vapors. The unit features DuraSource Technology, which offers improved IR life, and a HART port for easy output access.
-
product
Vapor Tension Thermometer
RF60A
UEi Test & Measurement Instruments
Farenheit and Celsius scale Vapor Tension thermometer
-
product
Special Application Thermal & Pressure Mass Flow Controllers
Certain process vapors and gases require mass flow controllers of a special design specific to the material as well as process conditions. MKS offers both thermal mass flow controllers and pressure based mass flow controllers for these applications that require flow control at elevated temperatures and/or low pressure drop conditions given the source material characteristics.
-
product
EpiStride SiC CVD System
Veeco’s latest technology for the compound semiconductor market enables high-performance chemical vapor deposition of Silicon Carbide for both 6 and 8-inch wafer production. The platform enables a return to production in under 5 hours after routine cleaning maintenance. The EpiStride system’s high uptimes, short cycle times and overall stable performance lead to the lowest cost of ownership per wafer compared to competitive systems.
-
product
MiniVap VP/VPL Vision
MINIVAP VP Vision is a highly versatile portable vapor pressure tester that features best-in-class precision and a pressure range of 0-2000 kPa. It is the first analyzer that demonstrates excellence in engineering by earning certificates for robustness and durability. Based on Grabner´s cutting-edge Cockpit™ technology, the instrument offers unmatched networking capabilities and enables worldwide access to analyzers.
