The EM-6883 is a small loop antenna intended primarily for use in the 30-300 MHz frequency range. When tripod mounted the loop exhibits a distinctly notched beam pattern useful for direction finding. Hand Held operation also allows probing for the location of signal sources.
The Electro-Metrics EM-6888 Radiating Stub fulfills the requirements of MIL-STD- 461D/462D, RE102. It is used as a reference standard to verify that the performance of calibrated antennas has not changed over time.
The EM-6890 Electrostatic Field Probe operates in conjunction with Electro-Metrics EM-2115 Interference Analyzer/Receiver, or any other 50 ohm receiver.
Current probes enable you to measure conducted current without direct connection to the circuit under test by clamping around the conductor, current carrying wire or structural member being tested.
The EM-6987 is capable of measuring signals and noise superimposed on power currents up to 300 A from DC to 400 Hz. Intermodulation effects on current probe output are also negligible.
The Electro-Metrics EM-6992 Hand Held Probe Set is designed to assist in pinpointing the specific source of emissions during the diagnostic testing phase of an EMI compliance investigation. A selection of probes of varying sensitivities is provided for both E-field and H-field analysis up to 1000 MHz.
Current probes enable you to measure conducted current without direct connection to the circuit under test by clamping around the conductor, current carrying wire or structural member being tested.
