Pickering Interfaces Inc.
Pickering Interfaces designs and manufactures modular signal switching and simulation for use in electronic test and verification. We offer the largest range of switching and simulation products in the industry for PXI, LXI, PCI & USB applications. Our products are specified in test systems installed throughout the world and have a reputation for providing excellent reliability and value.
- +44 (0)1255 687900
- sales@pickeringtest.com
- Stephenson Road
Clacton on Sea
Essex, CO15 4NL
United Kingdom
- PXI Chassis and Remote Controller
- Configurable PXI & PXIe Microwave Switch Platform
- PXI Power Supply Modules
- High-Voltage LXI Matrix Modules
- PXI Precision Programmable Resistor Modules
- PCI Precision Programmable Resistor Cards
- LXI 50 RF Matrix - 2.4GHz
- 25 Pin D-Type Cables - Connector to Unterminated for Pickering
- 25 Pin D-Type Cables - Connector to Unterminated
- Resistance Temperature Detectors (RTD) Simulators
- 2 Amp PXI Large Matrix Modules
- PXI Chassis
- 20-Pin GMCT Connector & Cable Accessories
- 25 Pin D-Type Cables - Connector to Connector for Pickering
- 25 Pin D-Type Connectors for Pickering
- PCI Switch & Simulation Cards
- LXI Switching Solutions
- LXI RF & Microwave Switching Solutions
- PXI Prototyping and Breadboard Modules
- PXI Attenuator Modules
- PCI Standard Programmable Resistor Cards
- PXI Simulation Modules For Sensor Simulation
- 25 Pin D-Type Connector Blocks for Pickering
- 68 Pin 1.27mm Pitch Micro-D Connectors for Pickering
- PXI Switch Solutions
- PXI Chassis And Remote Controllers
- Cables And Connector Solutions
- PXI High Voltage Amplifiers
- 20 Pin GMCT Cables - Connector to Unterminated for Pickering
- PXI Digital I/O Modules
- PXI Instrumentation Modules For Automated Test Systems
-
product
500-Pin SEARAY Cable Assembly, Male to Male, 2 Amp, 1m, 250 Port
A500RMR-500RMR-5C100
The 500-Pin SEARAY connector is used on switching products to provide a very high density 2A connector solution that is suitable for use to 200VDC. This cable assembly is suitable for direct connection to Pickering Interfaces products using the 500-Pin SEARAY connector. Screwlocks are provided to secure the cable assembly to a mating product.
-
product
PXI 10A Power MUX, 2-Bank, 8-Channel
40-661-102
The 40-661 is a single pole power multiplexer module, suitable for switching inductive/capacitive loads up to 10A with 125VDC/250VAC hot switching and 400VDC/250VAC cold switching. The multiplexer is available in 8-bank 4-channel, 5-bank 6-channel, 4-bank 8-channel, 2-bank 16-channel and 1-bank 32-channel formats. Also, 4-bank 4-channel, 2-bank 8-channel and 1-bank 16-channel half density configurations are available. Signal connections are made via front panel mounted 20-way GMCT plugs.
-
product
LXI Microwave Multiplexer, SP4T, 13-Bank, 18GHz, 50Ω, SMA
60-803-113
Our 60-803-113 is a 13 bank terminated SP4T multiplexer and is part of a range of LXI based microwave multiplexers suitable for switching 50 ohm signals up to 18GHz. The 60-803 range is capable of supporting up to 14 banks of terminated 4 channel multiplexers it is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA, SMA-2.9, SMA-2.4 or SMA-1.85 connectors.
-
product
PXI/PXIe Microwave Multiplexer, Dual SP6T, 50GHz, 50Ω, SMA-2.4
40-785C-552-TE
The 40-785C-552-TE (PXI) and 42-785C-552-TE (PXIe) are dual SP6T 50GHz microwave multiplexers with automatic termination of unused signals and remotely mounted relays. The 40/42-785C range of multiplexers are available as single or dual, SP6T or SP4T panel mounted multiplexers with relays mounted on the front panel. The single slot version can support up to three supplied remotely mounted multiplexers.
-
product
PXI 12-Slot BRIC Matrix, 352x4 2-Pole (8 sub-cards)
40-562B-322-352X4
The 40-562B-322-352X4 is a high density BRIC12 matrix module with a size of 352x4 with 2-pole switching. It is part of a range of BRIC matrices available in 2, 4, 8 or 12-slot formats to suit high performance PXI matrix requirements and is constructed using instrumentation quality reed relays.
-
product
PXI/PXIe Microwave Multiplexer, Single SP4T, 26.5GHz, 50Ω, SMA, Remote Mount
40-784B-131-E
The 40-784B-131-E (PXI) and 42-784B-131-E (PXIe) are single SP4T 26.5GHz unterminated microwave multiplexers with remotely mounted relays. The 40/42-784B range is available with single, dual or triple, SP6T or SP4T multiplexers with front panel mounted or remotely mounted relays.
-
product
PXI/PXIe Microwave Multiplexer, Dual SP4T, 18 GHz, 50 Ω, SMA, Failsafe
42-785C-422
The 40-785C-422 (PXI) and 42-785C-422 (PXIe) are dual failsafe SP4T 18 GHz unterminated microwave multiplexers. The 40/42-785C range of multiplexers are available in single or dual, SP6T or SP4T configurations with relays mounted on the front panel. Remote versions are also available which can support up to three multiplexers in a single slot.
-
product
PXI Prototyping Module, 2-Slot no Connector
40-225A-002
The 40-225A PXI Prototyping Modules are stripped down versions of the 40-220A PXI Breadboard series. These are very basic, low cost prototype modules. They have no PXI interface but do have access to fused power supplies from the PXI backplane.
-
product
PCI Programmable Resistor Card 2-Channel 3 Ohm To 131k Ohm
50-294-034
The 50-294 series of PCI Programmable Resistor cards are available with two channels of 16-bit, two channels of 12-bit or four channels of 8-bit resistor chains in a single card. These cards are ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
PXI 12-Slot BRIC Matrix, 384x8 1-Pole (6 sub-cards)
40-558-121-384X8
The 40-558-121-384x8 matrix is part of a range of BRIC ultra-high-density large PXI matrices are available in 2, 4, 8 or 12-slot PXI sizes to suit all high-performance matrix requirements and are constructed using Pickering Electronics' 4mm x 4mm instrumentation quality reed relays.
-
product
PXI Precision Resistor Module 9-Channel, 1.5 to 925
40-297-021
This 9-channel PXI Precision Resistor Module provides a simple solution for applications requiring accurate simulation of resistive sensors. The 40-297 series is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems. It is particularly well suited to applications such as the testing of engine controllers where resistive sensors provide information on parameters such as temperature.
-
product
PXI/PXIe Microwave Relay, Dual SPDT, 26.5 GHz, 50 Ω, SMA, Internal Termination, Failsafe, Remote Mount
40-781A-222-E
The 40-781A-222-E (PXI) and 42-781A-222-E (PXIe) are dual failsafe SPDT 26.5 GHz microwave relay modules with internal terminations and remotely mounted relays. The 40/42-781A range is available with one or two SPDT switches capable of switching frequencies up to 50 GHz in 50 Ω. They are available with either internal or external terminations and connections are via front panel mounted high quality SMA, SMA 2.9 or SMA 2.4 connectors.
-
product
20-Pin GMCT Male Connector, 16A, Without Backshell
92-960-020-16A-M
This accessory is designed to allow users to directly terminate a cable with soldered connections to the connector. It is supplied with removable solder bucket contacts suitable for wires up to 14 AWG. When the product is used without a backshell users should make their own cable strain relief arrangements and ensure appropriate electrical safety precautions are observed.
-
product
PXI 2-Slot BRIC Matrix, 276x4, 1-Pole (3 sub-cards)
40-560B-221-276X4
The 40-560B-221-276x4 is an ultra high density matrix module and is part of our range PXI BRIC matrices. They are available in 2, 4, 8 or 12-slot sizes to suit high performance PXI switching requirements and is constructed using instrumentation quality reed relays.
-
product
LXI Microwave Multiplexer, SP4T, 10-Bank, 26.5GHz, 50Ω, SMA
60-803-310
Our 60-803-310 is a 10 bank terminated SP4T multiplexer and is part of a range of LXI based microwave multiplexers suitable for switching 50 ohm signals up to 26.5GHz. The 60-803 range is capable of supporting up to 14 banks of terminated 4 channel multiplexers it is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA, SMA-2.9, SMA-2.4 or SMA-1.85 connectors.
Related
-
Virginia Panel Corporation
Virginia Panel Corporation (VPC) provides VPC provides Interconnect Solutions that enable simultaneous connection of multiple test and measurement signal types through one modular interface. Designed to accommodate signal, power, RF, thermocouple, pneumatic/vacuum, and fiber optic connector modules in multiple configurations, VPC’s innovative products meet the demands of test & measurement interconnect requirements.
