Cytec Corp.

Cytec Corporation is a privately held business incorporated since 1980 and located in Upstate New York. We offer more than 25 different standard Switching Systems and can custom design Switching Systems to meet our clients' requirements.

  • (800) 346-3117
    585-381-4740
  • 585-381-0475
  • 2555 Baird Rd.
    Penfield, NY 14526
    United States

Filter Results By:

Products

Applications

Showing recent results 76 - 80 of 80 products found.

  • Video and RF Switches and Matrix Switching Systems

    VDX Series - Cytec Corp.

    Cytec's VDX Series of video and RF switching systems are based on a solid state switch fabric and are available in non-blocking, full fan-out configurations of 16x16 to 32x32, with a bandpass of 400 MHz for 16x16 and 200MHz for 32x32. Input and output buffers can be added to the basic switch fabric allowing a broad range of both 50 and 75 ohm impedance signals to be switched.

  • VXI, VME, PCI and ISA Bus Products Catalog (6.3MB PDF)

    Cytec Corp.

    *Low cost solutions from the switching specialists.*MatricesMultiplexersPower Relays*Coaxial Matrices*Custom Models

  • Microwave Relays

    CXM/2x2 - Cytec Corp.

    CXM/2x2-F-SMA Microwave Relays have a Normally Closed (NC = OFF) and Normally Open (NO = ON) Position as shown in the drawing on the left. They can also be used as a terminated 2x1 relay. Usefull for swapping signals between devices, reversing signal flow or interfacing to larger configurations. Specifications Bandpass DC to 18 GHz Insertion Loss 0.3 dB @1 GHz, 0.8 dB @ 18 GHz VSWR 1.2:1 @ 1 GHz, 1.5:1 @ 18 GHz Isolation -80 dB @ 1 GHz, -60 dB @ 18 GHz

  • LX8/ID Modules

    Cytec Corp.

    LX8/ID modules have discrete circuits that can be used to detect contact sense, DC Volts, Current flow, AC sense, threshold voltage or whatever circuit you can dream up. Detection circuit is opto isolated and allows status feedback to your computer. See circuit examples in the drawing to the left. There are 8 circuits per module. Specify what circuit you would want on the prototyping section of the board. 20 Pin header connector for I/O.

  • Chassis

    CXM/128-MF - Cytec Corp.

    These Chassis controls up to 16 8x1 modules, 32 4x1 modules or mixtures of 8x1"s, 4x1"s, 2x1"s and 2x2 modules in any combination or configuration for up to 128 relay drives. LEDs on the front panel show switch and power status. Add Switch Modules, display / driver modules and a Control Module to complete the system or simply buy the chassis wired out to D connectors to control your own relays. A manual control is optional. Chassis is available with sink or source relay drivers from + 5 to + 28 volts, ot TTL drivers for programmable attenuators. Firmware commands for Fade and Handover for WiFi, Cell Phone and WiMax labs. Fully custom systems built with little to no NRE.