Test Transmitters

Enable a single technician to perform return band alignment with this easy to use return band alignment system for CATV. This system consists of a headend signal level receiver/telemetry transmitter (the HECTER 6103) and a small, field portable, dual-carrier signal generator/telemetry receiver unit (HECTER'S PUP 6106). ...more

The Fluke 787 was the first tool to combine a DMM and a loop calibrator to give process technicians double the power in one tool. Now its even better, the range is extended with the new Fluke 789 the ultimate loop calibration multimeter. The Fluke 789 has a 24-Volt loop supply reducing the need for taking a separate power supply when doing of ...more

The NPRT 2200 performs Noise Power Ratio measurements to determine the dynamic range of optical transmitters, amplifiers and other active devices used in HFC networks. It has an internal broadband noise source, selectable filters and a measuring receiver. ...more

Tripp Lite's Multi-Functional Network Cable Tester allows you to test wiring continuity for Cat5, Cat6, Phone and Coax cable assemblies. Identifies mis-wires, short circuits and open circuits. Features two piece transmitter and receiver, two BNC-F coax converters and coax terminator. ...more

The COM3010 is a full featured communications service monitor engineered and designed to provide highly accurate measurement and monitoring of communications equipment from 100kHz to 1.0GHz with 0.1ppm accuracy. Full duplex design enables independent and separate measurement and testing of transmitter and receiver circuits simultaneously making it ...more

CKC is now your one-stop source for Canadian testing and certification of wireless products. As a Certification Body (CB) for Canada, CKC-CS can now directly provide certifications for all manner of transmitters such as short range devices, 2.4 GHz spread spectrum devices, data transmission radios, medical transmitters, RF power amplifiers and ...more

Test and Training Range CEESIM provides emitter and scenario compatibility with other CEESIM systems. As a member of the Northrop Grumman Amherst Systems family of simulators, it generates signals with the same high fidelity as fullscale laboratory CEESIMs. All known EW emitters can be simulated to the highest level of accuracy. Available turn ...more

The DMC-1400 Calibrator fully documents any calibration easily while performing the normal job. No special software is required! It features the ability to test for pass/fail criteria, measure and simulate thermocouples, RTDs, current, voltage, and frequency, and source pulse trains. In addition, the built-in 250 Ohm resistor for HART compatibilit ...more

The PMP450 pressure transmitter is FUTEK?s precision engineered to fit most industrial pressure measurement applications. The compact, rugged design make this instrument suitable for applications including hydraulics and pneumatics, vacuum, test equipment, liquid level measurement, press control, compressor control, pump protection and numerou ...more

ComSonics X-Ray is the next generation ingress detection solution that takes the guess work out of finding leaks. The X-Ray system consists of a handheld meter featuring one button operation and a vehicle mounted ingress transmitter. By pressing the meters one button, the transmitter emits a coded pulsed signal, which permeates customer premise ...more

The M100A Optical Power Meter is the only low cost, extended range, fiber optic power meter available, capable of measuring the high power transmitters common to CATV head ends, without sacrificing the low measurement capability required for testing the longest telecomm cables or other applications requiring low level measurement capability. ...more

The Trilithic SpeedSweep System extends the 860 DSPi?s HFC plant maintenance functionality, giving techs the ability to test forward and reverse RF sweep response, in addition to a wide and growing range of signal analysis features. The forward sweep is transmitted from the model 8300 FST Forward SpeedSweep Transmitter, and the reverse sweep i ...more

Built-in multi-meter can be utilized for simultaneous testing / calibration of transmitters, regulators and other controllers without the read of using supporting equipment. 16801 can be programmed as a calibrator-tester with up to 10 steps of selected testing procedure.  ...more

The Protronix Modulation Meter 6020 is designed to meet transmitter testing needs. It is an automatic tuning and level setting instrument suitable for a wide range measurement on all kind of signal sources. The carrier frequency range from 1.5MHz to 2GHz which cover the frequencies used for Cordless Telephone, Handheld Telephone, Mobile Radio Trans ...more

The 2311FA Pressure Tester field tests aircraft pressure systems for both reciprocating and turbine engine pressure systems. It provides pressure for testing pressure transmitters, warning switches pressure-type torque (BMEP) indicators and system leak testing in the range of 0-600 PSI. ...more

Built-in multi-meter can be utilized for simultaneous testing / calibration of transmitters, regulators and other controllers without the read of using supporting equipment. 16801 can be programmed as a calibrator-tester with up to 10 steps of selected testing procedure.  ...more

APLAB Spectrum Analyzer can be used to observe and analyze wide variety of signals right upto 500MHz. Test different types of communication equipment. Test mobile handsets, cord-less phones, AM/FM transmitters and receivers. ...more

The N7612B Signal Studio software is used to configure partially or fully coded arbitrary baseband I/Q waveforms for testing TD-SCDMA components (amplifiers, filters, etc.), transmitters, receivers and chipsets. It complies with 3GPP TDD LCR standards and Chinese TD-SCDMA (CWTS) standards and can generate multicarrier signals (up to 12 carriers) fo ...more

The Agilent 86105B lets you perform transmitter compliance tests of multiple technologies and line rates with a single module. With this module, it is now possible to characterize optical transmission performance of all SONET, Ethernet, and Fibre Channel technologies, from 155 Mb/s through to 10 Gb/s. ...more

Provides the technician with a portable 24V power source for powering field transmitters. During startups, shutdowns, and overhaul periods, field loops are not usually energized;  yet the technician is still expected to be able to install, test and calibrate field instruments. The LPS2b fills this need.  ...more

The A3318 850 nm/Electrical OST Interface operates in conjunction with the Circadiant family of OSTs. It enables the OST to make stressed eye measurements in accordance with the IEEE 802.3ae standard using multi-mode fiber at a wavelength near 850 nm. Included electrical TX and RX interfaces allow testing of the high-speed electrical inputs an ...more

For uncomplicated and fast programming and test with the Telecom Tester 213. Telephones can be tested for ringing, DTMF, and acoustic in 30 seconds. All tests are carried out step by step by using only single key strokes. For development and quality assurance of handsets, the frequency response of receiver, transmitter, and sidetone can be show ...more

The A70 Wind Azimuth Transmitter monitors the signal from the Model A75-302 precision Potentiometric Wind Vane. The wind vane is balance to reduce errors should the vane mounting not be perfectly level. It is injection molded from black UV stabilized Lexan. It has proven rugged and reliable in field tests. The vane produces a signal proportional ...more

Perhaps you have considered buying a Checkmate but cannot justify its cost because you only do domestic and small commercial installations. No problem! By designing out the transmitter and adding a loudspeaker and 40ft reel test lead, you have Son of Checkmate - a sight and sound test meter at half the price.  ...more

Provides the technician with a portable 24V power source for powering field transmitters. During startups, shutdowns, and overhaul periods, field loops are not usually energized;  yet the technician is still expected to be able to install, test and calibrate field instruments. The LPS2a fills this need ...more