Loop Antenna

CISPR15, CISPR16, GB17743, GB/T6113comply with CISPR15, CISPR16, GB17743, GB/T6113;Mainly suitable for all kinds of lighting equipment, for measurement of the magnetic field strength in the X,Y and Z planes of a centrally placed EUT ...more

Mil Std 461D requirement RS-101 requires a method to verify that equipment under test are not susceptible to magnetic fields in the frequency range 30 Hz - 100 kHz. The RS-101 test requires the generation and monitoring of magnetic fields using loop antennas.  ...more

Passive Magnetic Loop Antennas (Transmit / Receive) 0 - 300 MHz. ...more

A.H. Systems' designs, manufactures and delivers high performance Loop Antennas for a wide range of magnetic field testing. Whether used in a set to measure shielding effectiveness per MIL-STD 285 and NSA 65-6 or individually to satisfy specific requirements, ...more

Fully automatic measurement of the magnetic field strength in the X, Y and Z planes of a centrally placed EUT; receiver / processor-controlled. ...more

Mobile TFD Broadband Antennas. The TFD (Terminated Folded Dipole) antenna operates as a loop antenna on which travelling waves are generated by means of a termination. A tuning unit is not required to attain the specified VSWR. The antenna is configured as an inverted V so that only one antenna support is needed. ...more

The PI 4100 is Potomac's third generation of precision survey instrumentation intended for the direct measurement of electromagnetic field strength in the 520 kHz to 5.1 MHz frequency spectrum. This instrument combines a laboratory quality radio frequency voltmeter, a calibrated, shielded loop antenna, an internal GPS receiver, an internal calibrat ...more

Mobile TFD Broadband Antennas. The TFD (Terminated Folded Dipole) antenna operates as a loop antenna on which travelling waves are generated by means of a termination. A tuning unit is not required to attain the specified VSWR. The antenna is configured as an inverted V so that only one antenna support is needed. ...more

This sensor is made up of a wide-band loop active antenna (from 100KHz to 110MHz) sensitive to magnetic fields and powered by rechargeable internal batteries. Using a plastic attachment anchored to the lower panel, the sensor can be plugged into the adapter supplied with the motorised support, with the desired polarisation. The RF signal interc ...more

The Active H-Field Measurement Antenna HM525 is a loop antenna. The voltage at its output is proportional to the amplitude of the alternating magnetic field applied. For overview measurements, the antenna can be operated in broadband mode in the total frequency range from 100 Hz to 30 MHz. To obtain maximum sensitivity, the antenna can be loca ...more

The EM-2150A is compatible with any of the usual test accessories, including antennas, probes, PLISN?s and oscilloscopes. Several antennas typical of those that may be used are:  EM-6870 Loop Antenna. EM-6879 Loop Antenna. EM-6892 Remote Active Vertical Antenna.  EM-6912A Biconical Antenna. EM-6950 Log Periodic Antenna ...more

Com-Power EMI / EMC broadband and tuned antennas cover the frequency range of 9 kHz - 40 GHz for EMI/EMCTesting. They can be used for both radiated emission and immunity testing (antenna used as a transmitter to generate electromagnetic field). ...more