Search Results for Gates / Analog

  • SR250 - Gated Integrator, 2 ns Minimum Gate Width The SR250 Gated Integrator is a versatile, high-speed, NIM module designed to recover fast analog signals from noisy backgrounds
    Stanford Research
  • PAS 9742/DO - Receiver Gate Generator andVME Analog Output Card The PAS 9742/DO is a VME based, pulse generator and eight-channel analog output card. This card generates two digital output signals in response to a sync pulse input. These two TTL level output signals are known as Receiver Gate, (RG) and Time of Arrival, (TOA). Two, 32 bit wide registers on the card, which are written to over the VME bus, control the width of the pulses.
    Precision Analog
  • PD-4 - Professional Partial Discharge Measuring System diagnosis of high voltage insulation systems fulfils standard IEC 60270 selectable broad band filters tuneable narrow band filter combined analogue and digital display interference gating with up to 6 individually adjustable gates. Real analogue or digital processing?
    PRESCO AG
  • 4100 Series - Digital Boxcar Averager Systems NIM based modules that can be employed to create a single or multiple channel boxcar averager system. 20 mV sens, 1.5ns gate, 400 MHz bandwidth, 20 ns intrinsic delay, 80 kHz trigger rate, baseline sampling, externally controllable analog delay.
    Signal Recovery
  • NI PCI-7831R - R Series Multifunction RIO with Virtex-II 1M Gate FPGA 8 analog inputs, independent sampling rates up to 200 kHz, 16-bit resolution, ±10 V 8 analog outputs, independent update rates up to 1 MHz, 16-bit resolution, ±10 V 96 digital lines configurable as inputs, outputs, counters, or custom logic at rates up to 40 MHz Virtex-II 1M gate FPGA programmable with the LabVIEW FPGA Module
    National Instruments
  • NI PXI-7831R - R Series Multifunction RIO with Virtex-II 1M Gate FPGA 8 analog inputs, independent sampling rates up to 200 kHz, 16-bit resolution, ±10 V 8 analog outputs, independent update rates up to 1 MHz, 16-bit resolution, ±10 V 96 digital lines configurable as inputs, outputs, counters, or custom logic at rates up to 40 MHz Virtex-II 1M gate FPGA programmable with the LabVIEW FPGA Module
    National Instruments
  • NI PXI-7833R - R Series Multifunction RIO with Virtex-II 3M Gate FPGA 8 analog inputs, independent sampling rates up to 200 kHz, 16-bit resolution, ±10 V 8 analog outputs, independent update rates up to 1 MHz, 16-bit resolution, ±10 V 96 digital lines configurable as inputs, outputs, counters, or custom logic at rates up to 40 MHz Virtex-II 3M gate FPGA programmable with the LabVIEW FPGA Module Connectivity to the NI 9151 for I/O expansion and low-cost signal conditioning
    National Instruments
  • System 2217 - L-Band Radar Recorder The System 2217 is a sophisticated data acquisition system that is designed to record L-band radar signals for analysis. In operation, between two and sixteen independent intermediate frequency analog signals are recorded to a Fibre Channel RAID storage unit. An external sample clock running at up to 105 MHz synchronizes all sixteen channels and a low-voltage TTL signal is used to gate the acquisition.
    DspCon
  • F2850 - Freq. Counter 10Hz 3GHz Hi-Z low range 10-Digit Liquid Crystal Display Ultra-sensitive; synchronous detector-16-section bargraph to show RF signal strength High Speed 300MHz Direct Counter with 0.1HZ Resolution Filter to Prevent Display of Random Noise Automatic hold; LED back light; beeper Four selectable gate speeds Low power consumption (average 6 hour battery life) Supplied with NiCd pack; AC wall charger; 7 section telescopic antenna Low battery indicator IMPORTANT: This unit only works with analog signals
    Elenco Electronics
  • CS2-TM - DIGITAL INDICATOR & CONTROLLER Measuring 0~50/60/100mVdc from shunt or 0~10V/0(4)~20mA from flow-meter and other application Dual display screen for totalizer & batch or PV (immediate value) programmable, so that it's easier to be a batch controller Accuracy of PV (immediate value): +/- 0.04%; Display range: -19999~29999 4 banks pre-set for all relay functions relative 4 difference scaling, and selectable by 3 External Control Inputs (E.C.I.) Or front key 4 relay for *PV (immediate value) Hi / Lo energized with Start Delay / Hysteresis / Energized & De-energized Delay / Relay Energized Hold.... functions and *totalizer & batch N / C / R mode programmable 3 external control inputs for PV Hold / Reset for Maximum or Minimum Hold / Reset for Relay latching / DI / Reset & Gate for Totalizer and/or) Batch.... Pulse, Analogue output and RS 485 communication port in option
    Power True Systems
  • RFIC - GoldenGate RFIC Simulation Software GoldenGate RFIC Simulation and Analysis Software is an advanced simulation and analysis solution for integrated mixed signal RFIC designs that is fully integrated into the Cadence Analog Design Environment (ADE). GoldenGate is part of Keysight's RFIC simulation, analysis and verification solution that also includes Momentum for 3-D planar electromagnetic simulation, SystemVue & Ptolemy wireless test benches for system-level verification, and the Advanced Design System (ADS) Data Display for advanced data analysis. This suite links the RF system, subsystem, and component-level design and analysis as part of a unique and comprehensive RFIC design flow.
    Keysight Technologies

Results 1 - 11 of 11

Search Filters

  • Analog x

Manufacturers

View All (9)Hide List

Categories

Features