Antenna Measurement

The WIRELESS WIZARD is the only complete 2.4 GHz and 5 GHz Wi-Fi measurement system. It includes a handheld, battery operated spectrum analyzer, directional and omni-directional antennas, power adapters for line voltages worldwide as well as 12 VDC, and PC software for downloading measurement data including automated data logging capability.&n ...more

The Dual Buddy sat finder is a satellite signal meter that measures relative RF signal strength when connected to a dish antenna. The Dual Buddy's two input connectors and switching capabilities allow the measurement of separate satellite feeds and simultaneously display their relative signal strength, alowing the installer to easily balance a ...more

No need to call for a radio check when you have this compact, easy to use, unit on-board. Unlike other meters in its class, the ART-3 tests receiver function as well as output power and VSWR (antenna efficiency). Frequency Range: 155-158 MHz; RF Power Scale: 0 to 30 watts. Antenna and Radio Tester, tests Tx and Rx. ...more

The NSI model 700S-200 is an ideal system for measuring radiation characteristics of vehicle mounted antennas. The system interfaces with a wide variety of NSI, Agilent, or R&S RF equipment. The Model 700S-200 includes NSI's NSI2000 Antenna Measurement Software. The system software runs on a Pentium based measurement workstation and provide ...more

Site validation measurements according to EN 50147-2 and ANSI C63.4. All purposes of broadband precision field-strength measurements. Technical Data for PBA 320. Frequency range: 30 MHz - 200 MHz ...more

Exposure evaluation next to mobile communication facilities e.g. GSM and UMTS base stations. Accurate RF radiation safety measurements e.g. nearby broadcast stations or in buildings. All kinds of field strength measurements where high precision, a wide frequency range and small antenna dimensions are required. Measurements according to our Field No ...more

Measurement software for MSK 33; enabling measurement and protocolling of antenna systems in range 47-862 MHz with PC or Laptop ...more

RefRad 3000 is a battery operated comb generator for producing a well defined field strength for testing the performance of EMC and EMF measurement systems in the frequency range of 1 MHz to 3 GHz. designed for a rapid system checkout of your frequency selective EMF-test system (e.g. Field Nose) or your EMC radiated emission test setup by generatin ...more

Signal meter Sat/TV/FM; analogue/digital antenna measurement system; TFT display 10,4"; touch screen; spectrum, const. analysis; oscilloscope ...more

The Model 4100 Wireless Test Lab is specifically designed for mobile video applications, both terrestrial and satellite. It is designed with thicker absorber to allow it to operate down to 400MHz and a longer range length to keep the measurement antenna out of the reactive near-field of the equipment under test. ...more

The NSI-RF-60001E is a high performance antenna measurement system based on the NSI Panther Receiver, High Speed Beam Controller, NSI Panther 7002 dual source (single unit includes both RF & LO sources) and the NSI Integrated Frequency Converter. ...more

The NSI-RF-PNA20-003 is a high performance antenna measurement system based on the Agilent PNA Vector Network Analyzer and the NSI-RF-5940 Distributed Frequency Converter. PNA option H11 is used to access the internal PNA LO source, uses an input IF of 8.33 MHz (compatible with NSI DFC) and also supports pulse mode operation. Other PNA options ...more

The PM5K represents a breakthrough in features for measurement of teh performance of your transmitting system. Microprocessor control insures fast capture time and low poer consumption. With the ability to monitor your VSWR and power levels at all times, you will know that your transmitter, Rf source and load, or antenna systems are operating effec ...more

The NSI-RF-60001A is a very high performance antenna measurement system based on the NSI Panther Receiver, High Speed Beam Controller, dual Comstron 20 GHz sources (RF & LO) and the NSI Distributed Frequency Converter with remote mixers. The system block diagram is shown below. ...more

The NSI-RF-60001D-26 is a high performance antenna measurement system based on the NSI Panther Receiver, High Speed Beam Controller, dual Panther 7020 20 GHz sources (RF & LO), 18 - 26.5 GHz Frequency doubler and the NSI Distributed Frequency Converter with remote mixers. The system block diagram is shown below. ...more

NSI offers broadband ridged waveguide probe (RGP) antennas for use as near-field measurement probes. The wide bandwidth of these probes allow replacement of several standard Open Ended Waveguide (OEWG) Probes, eliminating the need to change probes frequently. The probe is delivered with typical measured probe correction data from NSI to serv ...more

The NSI-RF-60001D is a high performance antenna measurement system based on the NSI Panther Receiver, High Speed Beam Controller, dual Panther 7006 sources (RF & LO) and the NSI Integrated Frequency Converter. The system block diagram is shown below. ...more

 10 M ~ 2500MHz to direct reading in the frequency field intensity was measured. ROKESHONANARAIZA, broadband radio frequency corresponding to the electric field intensity and frequency of measurement instruments in a variety of antenna performance comparison  ...more

The NSI-RF-PNA20 is a high performance antenna measurement system based on the Agilent PNA Vector Network Analyzer. ...more

Our multi frequency filter MFF-1 is easy to connect between the measu- rement antenna and the measure- ment device HF (HFR-1, HRF-2, PDM, broad band high frequency measurement device sold in the market). Different frequencies ran- ges can be selected by means of an easy commutation.  ...more

The NSI-RF-60001B is a high performance antenna measurement system based on the NSI Panther Receiver, High Speed Beam Controller, dual Agilent VXI E6432A 20 GHz sources (RF & LO) and the NSI Distributed Frequency Converter with remote mixers. ...more

The Integrated Frequency Converters (IFC) were designed to provide a low-cost down-converter suitable for antenna measurement applications where RF cable losses are small.The IFC provides one test and one reference channel in a single rack mount enclosure. ...more

Com-Power broadband high gain preamplifiers were designed for electromagnetic interference (EMI) testing and certification. EMC test labs use preamplifiers to improve sensitivity of the test system during EMI radiated emissions measurements. Without a high gain preamplifier, signals picked by the antenna that have amplitudes below the noise fl ...more

The NSI model 800F-10 Far-field Antenna Measurement System is a cost-effective, easy-to-use system for taking principle-plane, far-field antenna measurements. This system is compact and lightweight. It is ideal for universities or small commercial companies that want to test small, lightweight, and low gain antennas. ...more

The NSI-RF-PNA20-002 is a high performance antenna measurement system based on the Agilent PNA Vector Network Analyzer, dual Agilent PSG sources and the NSI-RF-5940 Distributed Frequency Converter. PNA option 014 (Reconfigurable Test Set) is used. The ...more