T-200 High Power Traveling Wave Tube Amplifiers
Status Indicators: Power On, Standby, RF On/Operate Faults: Helix Overcurrent, VSWR Overload, Thermal Overloads, Air Flow, Collector Overcurrent. Designed to meet the safety requirements of the IEC-348 and Underwriters Labratory of American Standards
|
Instruments for Industry, Inc
731 Union Parkway
|
| Related Products |
-
50-725-751 PCI 8x9 RF Matrix 500MHz 75 Ohm mini SMB Pickering Interfaces Contact Info Send To Colleague 
8 x 9 RF Matrix Module suitable for switching frequencies to beyond 500MHz. The 50-725 is available in either 50 Ohm or 75 Ohm versions with a choice of coaxial connectors. It is intended for the easy construction of high performance bidirectional matrix switching systems. Automatic Isolation Switches are located on all coaxial connectors, the ...more -
LOCATOR-I - High Density Probe Fixture ProbeStar Contact Info Send To Colleague 
Meeting the challenge for testing next-generation Consumer Electronics, the LOCATOR-I fixture is uniquely designed for small PCBA's that require high density probe patterns (over a 150 probe-pins within a 1.5" square area). Typical applications include accessing fine pitch circuits for RF products. ...more -
3210C - AC Current Calibrator Krohn-Hite Corporation Contact Info Send To Colleague 
The Model 3210C is a 100A AC Source/Calibrator and is an accurate voltage to current amplifier or transconductance amplifier. The current output is directly proportional to the input voltages from a high accuracy ac voltage standard. The AC voltage bandwidth is 40Hz to 500Hz. The 3210C is calibrated with instruments and load resistors traceabl ...more -
CR103J - DC Source / Calibrator Voltage and Current Krohn-Hite Corporation Contact Info Send To Colleague 
This DC Source/Calibrator instrument is of solid-state, hybrid design with a long history of reliability. The fundamental design is conceptually simple and straightforward (see block diagram). The Model CR-103/J is comprised of two complete instruments. The dc voltage section is an ultra-stable, chopper stabilized amplifier with selectable pre ...more -
VDX Series - Video and RF Switching Systems Cytec Corp. Contact Info Send To Colleague 
CYTEC's VDX Series of Video and RF Switching Systems are based on a solid state switch fabric and are available in non blocking (any input to any output), full fan-out (any input to all outputs) configurations from 1x8 to 32x32, with bandpass to 200 MHz. The standard switch may be used as a 75 ohm Video or DS3/T3 Matrix. Input and output buffe ...more
